Abstract:The (1 − x)(Li 0.03 Na 0.5 K 0.47 )(Nb 0.92 Sb 0.05 Ta 0.03 )O 3 –xBa 0.85 Ca 0.15 Zr 0.1 Ti 0.9 O 3 (LNKNST–BCZT, x = 0, 0.5, 1.5, 2.5, and 3.5%) lead-free piezoceramics were synthesized by the conventional solid-state reaction method with adding nano-sized Ba 0.85 Ca 0.15 Zr 0.1 Ti 0.9 O 3 (BCZT) powder to investigate their influences on crystal structure and electrical properties. The X-ray diffraction (XRD) analysis reveals that all the sintered LNKNST–BCZT ceramics exhibit pure perovskite structure with the mainly rhombohedral (R) phase or the coexistence of rhombohedral (R) phase and tetragonal (T) phase. The composition of the LNKNST–1.5%BCZT ceramics locates around the critical point, i.e., the ceramics changing from the coexistence of rhombohedral (R) phase and tetragonal (T) phase to purely rhombohedral (R) phase, and presents the most densified microstructure morphology, which can be confirmed further by the field emission scanning electron microscope (FESEM) observation. There are two dielectric anomalies in the temperature dependent dielectric properties curves of the LNKNST–BCZT ceramics, which correlate with the ferroelectric rhombohedral (R) phase changing to the ferroelectric tetragonal (T) phase, and then to the paraelectric cubic (C) phase. Both the Curie–Weiss law and the power law fittings confirm the diffuse phase transition ferroelectrics characteristic of the LNKNST–1.5%BCZT ceramics, which is considered as correlating with the polar nanoregions (PNRs). Due to the densification effect caused by the chosen amount of nano-sized BCZT doping and the construction of R–T polymorphic phase boundary, the LNKNST–1.5%BCZT ceramics exhibit the best ferroelectric and piezoelectric properties. The complex impedance spectroscopy analysis confirms that the extrinsic electrical conduction mechanism at high temperatures is dominated by the oxygen vacancies induced by the evaporation of the alkali metals during sintering.

High-performance Electrical Properties of La-based Perovskite Ceramics for the Functional Phase of Thick Film Resistors

Low-temperature Solid Oxide Fuel Cells with Novel La0.6Sr0.4Co0.8Cu0.2O3−δ Perovskite Cathode and Functional Graded Anode

High–performance Copper–substituted La0.5Sr0.5CoO3 Ceramics As Economical Functional Materials for Thick Film Resistors

Evaluation of Zn‐substituted La0.5Sr0.5CoO3 Ceramics As Functional Materials for Thick‐film Resistors

The Sintering and Electrical Properties of Zn-substituted LaCo0·4Ni0·6O3 Ceramics Based Upon Experiments and Calculations

Improved Nb–substituted La0.5Sr0.5CoO3 Ceramics As New and Low–cost Functional Materials for Thick–film Resistors

Experimental And Theoretical Study On The Resistive Properties Of Laco0.4ni0.6o3 Ceramic With Mg-Ion Substitution

Low temperature coefficient of resistance and high conductivity: Enhanced Cu–substituted LaCo0.4Ni0.6O3 ceramics for functional material

Effects of nano-sized BCZT on structure and electrical properties of KNN-based lead-free piezoceramics

LaCr1-xFexO3 (0≤x≤0.7): A novel NTC ceramic with high stability

Experimental and theoretical study on enhanced electrical properties of nickel-substituted La<sub>0.5</sub>Sr<sub>0</sub><sub>.5</sub>Co<sub>0.</sub><sub>3-</sub> ceramics

Experimental and theoretical study on enhanced electrical properties of nickel-substituted La0.5Sr0.5CoO3−δ ceramics

Enhanced thermistor performance of LaCrO 3 through high-entropy strategy

High resistivity under colossal permittivity SrTiO3 based ceramic via controlling ion diffusion

Electrical Characterization of 0.6mgal 2 O 4 -0.4La 1− X Sr X CrO 3 High Temperature NTC Thermistors

Characterization And Stability Of La0.7sr0.3co0.3fe0.7o3 Perovskite-Type Oxide

High Insulation Resistivity and Ultralow Dielectric Loss in La-Doped SrTiO3 Colossal Permittivity Ceramics through Defect Chemistry Optimization

Synthesis, Structural, Electrical and Microchemistry Properties of Novel (LSCFM) LaxSr1-xCo1-y-zFeyMnzO3-δ (x=0.4, 0.6, 0.8, y=0.4, 0.8 and z=0.1, 0.2) Perovskites for SOFC Applications

Effect of V Substitution on the Electrical Properties of La 0.5 Sr 0.5 Co 1− X V X O 3 ( X = 0.00–0.10) Ceramics

MgAl 2 O 4 –LaCr 0.5 Mn 0.5 O 3 composite ceramics for high temperature NTC thermistors

Preparation And Electrical Properties Of Interconnect Material Made By Substituting Mixed Rare Earth Oxides (Sm2o3, Gd2o3, Eu2o3 And Ceo2) For La2o3 In La1-Xcaxcro3 (0.1 <= X <= 0.4)