Abstract:The performance of superconducting magnets is greatly dependent on the size and uniformity of the superconducting filaments within the wire. However, in the fabrication of Bi 2 Sr 2 CaCu 2 O x (Bi2212) wires using ceramic oxide as the superconducting filaments, we face multiple challenges including filament fragility, poor uniformity, and non-smooth Ag/superconductor interfaces. These challenges primarily stem from the significantly lower plastic deformation capability of ceramic oxide powder filaments compared to metal matrices. To address these challenges, this study focuses on the modification of ceramic oxide precursor powders. Through the utilization of low-temperature, low oxygen partial pressure ( p O 2 ) heat treatment, we have observed significant changes in the Cu chemical states and lattice parameters within the Bi2212 grains. These alterations have proven to be highly effective in reducing the energy required for grain sliding and, in turn, enhancing the plastic deformation properties of the Bi2212 oxide filament. Furthermore, post-annealing the oxide powder under low p O 2 conditions narrows the gap in plastic deformability between the Ag sheath and the oxide filaments, resulting in improved filament uniformity and a smoother Ag/oxide interface in Bi2212 wires. Notably, the Bi2212 grains exhibit an orderly arrangement within the wires. As a result of these improvements, the critical current density ( J c ) of the final wires increases by an impressive 70 %. The outcomes of this study are not only crucial for producing Bi2212 magnets with higher magnetic field strength, improved magnetic field uniformity, and enhanced operational stability, but also offer fresh insights and methodologies for advancing the field of superconducting materials.

Effect of ultrasonic-vibration drawing process on Bi-2212 round wires

Improving Bi-2212 multi-filament wire quality and superconductivity by cryogenic drawing

Critical current density improvement by intermediate deformation for the fabrication of Bi 2 Sr 2 Ca 2 Cu 3 O 10+δ /Ag round wires

Investigation on the Effect of Ultrasonic Vibration on Reduction in Drawing Force

Investigation on Drawing Process of Bi-2223/Ag Wires Using Racetrack-Type Dies: Simulation and Experiments

Improvement of plastic deformation property and current carrying capacity of Bi2212 wires through low oxygen partial pressure post-annealing of precursor

Investigation on the Drawing Process of the Bi-2223/Ag Wire Based on the Physics of Inhomogeneous Inorganic Materials Method

EFFECT OF HEAVILY DRAWING ON THE MICROSTRUCTURE AND PROPERTIES OF Cu-Cr ALLOYS

Experimental research of the titanium alloy wire drawing with high power ultrasonic vibration

Relating Residual Stress and Microstructure to Mechanical and Giant Magneto-Impedance Properties in Cold-Drawn Co-based Amorphous Microwires

Large critical current density improvement in Bi-2212 wires through groove-rolling process

Microstructure and Critical Current Density of Bi-2212 Single- and Multi-filamentary Wires with Overpressure Heat Treatment Processing

Uniaxial Strain Induced Critical Current Degradation of Ag-Sheathed Bi-2212 Round Wire

Groove-rolling as an alternative process to fabricate Bi-2212 wires for practical applications

Investigate on the Application of Elliptical Drawing Dies During the Manufacturing Process of Bi-2223/Ag Superconducting Tapes

Effect of Superimposed Ultrasound on Mechanical Properties of Copper

The effect of cold drawing on the structure, tensile fracture strength and reliability of CuZrAl amorphous microwires

Performance and Microstructure of Bi-2212 Wire under Different OverPressures Heat-treatment

Revealing the effect of bridges in the multi-filamentary Bi-2212 wires

Strain Compatibility Behavior in Cu-6%Ag Alloy During Drawing into Filamentary Structure

Development of persistent joints for superconducting Bi-2212 coils