Abstract:Ultrasonic wedge bonding of aluminum (Al) wires is a widely applied interconnect technology for power elec-tronic packaging. The joint quality of the wedge bonding is mainly affected by the process parameters and material properties. Inappropriate process parameters will lead to failure modes such as chip surface pit, metal layer peeling off, wire cracking, non-sticking to the pad, etc., which limits the long-term stability of power devices. In order to reach the desired reliability, the design of experiment (DoE) is generally deployed which is costly in terms of time and related materials. Therefore, simulation-assisted analysis is in demand to rapidly narrow down the process windows. In this paper, an ultrasonic bonding model involving thick Al wires (300 mu m) was established based on the Finite Element Method (FEM), to optimize process parameters effectively with reduced time and cost. The model was designed in ANSYS utilizing the transient structural mechanics module with various stresses and ultrasonic power, to simulate the relative deformation of the bonded wires and the displacement against the substrate. The result was then verified by ultrasonic wedge bonding samples with 9 sets of process parameters. The stress distributions were simulated and analyzed with the failure modes of tensile strength tests, while the deformation of wires under various process parameters was measured and compared with shear strength tests. Further, the relationship between the failure modes of the joint and the deformation was then analyzed by Response Surface Method (RSM), and the regression equation of the wire deformation and related process parameters was established and fitted with the actual sample's data. Such analysis not only found the optimum range of the deformation of thick Al ultrasonic wire bonds but also quickly provided a range of optimized processes for Al thick wires applying ultrasonic wedge bonding techniques.

Experimental research of the titanium alloy wire drawing with high power ultrasonic vibration

Experimental Research of the Wire Drawing with Composite Ultrasonic Vibration Imposed by Anti-Pull

Investigation on the Effect of Ultrasonic Vibration on Reduction in Drawing Force

Enhanced Tensile Properties And Fracture Reliability Of Cu-Based Amorphous Wires Via Pr-Doping

RESEARCH ON WIRE-DRAWING OF A H0Cr17Ni6Mn3 STEEL WITH HIGH-DENSITY CURRENT PULSES

EFFECT OF HEAVILY DRAWING ON THE MICROSTRUCTURE AND PROPERTIES OF Cu-Cr ALLOYS

Investigation on Preparation Process for High Strength Ti-6Al-4V Wire

The effect of cold drawing on the structure, tensile fracture strength and reliability of CuZrAl amorphous microwires

Research on turning of titanium alloy based on the electro-plastic-ultrasonic vibration coupling effect

Study on the Simulation and Experiment of Ultrasonic-assisted Vibration Drilling of Ti6Al4V

Research on Melt Degassing Processes of High Conductivity Hard Drawn Aluminum Wire

Numerical and Experimental Investigation of Trapezoidal Wire Cold Drawing Through a Series of Shaped Dies

Effect of the techniqie of drawing with shear on the structure and the properties of low-carbon wires

Development of Wet Wire Drawing Machine and Pass Schedule With Ultra High Speed for High Carbon Steel Wire

Effect of Current Pulses on the Drawing Stress and Properties of Cr17Ni6Mn3 and 4J42 Alloys in the Cold-Drawing Process

Development of Ultrasonic Vibration Assisted Uniaxial Tension Device and Utilization in Evaluation of Micro Tension Deformation Behavior of Copper Foil

Finite element modeling and analysis of ultrasonic bonding process of thick aluminum wires for power electronic packaging

New method for improving strength and plasticity of steel wire

Improving Mechanical Property of Austenitic Stainless Steel Wire by Cryogenic Forming

Enhancement of wire electrochemical micromachining of 40CrNiMoA with electrolyte ultrasonic assistance