Abstract:Composite cylindrical pressure hulls are thin-walled structures widely used for autonomous underwater vehicles. Buckling failure is one of the most important failure modes for these shells under external pressure. In existing buckling studies of cylindrical pressure hulls, FEM is the most popular analysis method but not efficient enough when dealing with structures with complex material distributions such as the variable stiffness composite shells. Motivated by this, an isogeometric method for buckling prediction and post-buckling analysis of variable stiffness composite underwater pressure shell is proposed in this article. In this method, based on Reissner-Mindlin shell formulas undergoing large deformation, a buckling analysis framework in IGA forms is established. Then a modified arc-length method is proposed based on kinematics used in the shell formulas, and is used to overcome the inaccuracy caused by the 2 degrees of freedom node rotation in the prediction step of arc-length method. In addition, the influence of bifurcation is considered, which may seriously affect the precision of buckling behavior simulation when the limit point is close to a bifurcation point. The computational accuracy of this framework has been validated in a series of constant stiffness composite shell cases involving buckling load prediction and post-buckling behavior simulation. For variable stiffness composite hull cases, this framework achieves the same precision as FEM with fewer elements. Therefore, the proposed framework provides an efficient way for the buckling design of underwater variable stiffness composite pressure hulls.

Assessment of DBA-L Pressure Vessel Design Method by a Cylindrical Vessel with Hemispherical Ends

Evaluation of DBA-L pressure vessel design method by 2D and 3D solid models

A New Pressure Vessel Design by Analysis Method Avoiding Stress Categorization

Reliability Assessment of Pressure Vessel Design Methods

Localized Perturbation Load Approach for Buckling Design of Thin-Walled Steel Cylindrical Shells under Partial Axial Compression

Advances in "design by Analysis" Methods for Pressure Vessels

Comparison of design methods for internally pressurized ellipsoidal head

A New Design Method For Axially Loaded Thin-Walled Cylindrical Shells Based On Elasto-Plastic Buckling Analysis

Limit pressure and design criterion of cylindrical pressure vessels with nozzles

The Method of Design by Analysis for Cylindrical Pressure Vessels with Spherically Dished Head

Design of Axially Loaded Isotropic Cylindrical Shells Using Multiple Perturbation Load Approach – Simulation and Validation

Engineering assessment method for LBB stability analysis in pressure vessels and pipes

Local Stress Analysis of Cylindrical Shells due to Branch Pipe Moments

Safety analysis of pressure piping containing incomplete penetration under combined loads

Analytical Study on the Buckling of Cylindrical Shells with Stepwise Variable Thickness Subjected to Uniform External Pressure

Analysis of the Elastic-Plastic Buckling Behavior of the Pressure Vessels with Dished Heads under Internal Pressure

A Stress Analysis Method for Cylindrical Shells With Nozzles Subjected to Internal Pressure, External Forces and Moments

Isogeometric Method for Buckling Prediction and Post-Buckling Analysis of Variable Stiffness Composite Underwater Pressure Shell

Burst Pressure of Pipelines with Plastic Anisotropy under Combined Internal and External Pressures

A New Method of Stress Linearization for Design by Analysis in Pressure Vessel Design

Discussion on the Implementation of the Primary Structure Method in Design by Analysis