Abstract:Coarse tungsten powders are usually used as raw material for preparing coarse grained WC-Co cemented carbides. Sodium can effectively promote the growth of tungsten powder during the reduction of tungsten oxide with hydrogen. Conventional addition of sodium salt into tungsten oxide powders by mechanical milling has the disadvantage of uneven distribution of sodium, which leads to abnormal growth of tungsten powders and affects the performance of WC-Co cemented carbides. In this study, uniform sodium doped ammonium paratungstate (APT) was prepared by adding sodium carbonate into ammonium tungstate solution during the evaporation and crystallization process based on the formation of ammonium-sodium paratungstate. Experimental results showed that sodium was uniformly distributed in the APT and promoted the growth of APT crystal. The sodium-doped APT was then used to produce coarse tungsten powders. Compared with tungsten powders obtained from tungsten trioxide with addition of sodium by mechanical milling, the coarse tungsten powders had larger average particle size and more uniform particle size distribution . The coarse tungsten powders were subsequently prepared into tungsten carbide powders and WC-Co cemented carbides by carburization and pressure sintering, respectively. Results showed that the obtained WC-Co cemented carbides had larger average WC grain size (6.8–7.2 μm), higher fracture toughness and transverse ruptures strength, and more uniform microstructure than that of WC-Co cemented carbides obtained by addition of sodium with mechanical milling. Moreover, sodium thoroughly volatilized during hydrogen reduction and carburization process, so that the purity of WC-Co cemented carbides was not reduced. Therefore, this study provided a new route for preparation of extra coarse-grained WC-Co cemented carbides.

Preparation Technology of Ultra-Fine Tungsten Carbide Powders: an Overview

Ultrafine/nano WC-Co Cemented Carbide: Overview of Preparation and Key Technologies

Preparation of Ultra-Fine WC-Co Cermet and Its Wear Behavior

Enhanced the Mechanical Properties and Corrosion Resistance of Ultra-Coarse Grain WC-8Co Cemented Carbides by the Introduction of Cu and Ni

Preparation of nano-scaled WC powder by low-temperature carbothermic reduction method

A short and facile process to synthesize WC-Co cemented carbides

Preparation, properties and microstructure of high hardness WC-co cemented carbide tool materials for ultra-precision machining

Research on Preparation Methods of Ultra-coarse WC Particles

Preparation Technology of Ultrafine WC-CeCo Cemented Carbide

Effect of Metal Elements on Microstructure and Mechanical Properties of Ultrafine Cemented Carbide Prepared by SPS

Study on influencing factors and mechanism of high-quality tungsten carbide nanopowders synthesized via carbothermal reduction

Ultrafine WC-Ni cemented carbides fabricated by spark plasma sintering

Rapid synthesis of ultrafine WC-Co cemented carbides by in-situ reactions and spark plasma sintering

Synthesis of Nano Tungsten Carbide Via Loose Yellow Tungsten Oxide Rod Processing

Peculiarities of Preparation and Properties of Cemented Carbide WC + 20 Mass% Ni with Ultra-Coarse-Grained Microstructure

Cemented Tungsten Carbide Hardmetal-An Introduction

Fabrication of tungsten oxide powder from WC–Co cemented carbide scraps by oxidation behaviour

Ultrafine Binderless WC-based Cemented Carbides with Varied Amounts of AlN Nano-Powder Fabricated by Spark Plasma Sintering

Preparation and characterization of W@WCx composite powder by oxidation-vacuum carbonization process

Additive manufacturing of WC-Co cemented carbides: process, microstructure, and mechanical properties

Preparation of extra coarse-grained WC-Co cemented carbides by doping sodium in the ammonium tungstate solution during evaporation crystallization process