Abstract:Suspension effect poses a big threat to the integrity and safety of corroded pipelines. In this work, a finite element (FE) based multi-physics field coupling model was developed to determine the mechano-electrochemical (M-E) interaction at an external corrosion defect on a suspended X100 steel pipe and predict its failure pressure. Theoretical calculations were used for model validation. Parameter effects including the defect location on the pipe, geometry of the defect, suspension length and pipe burial depth were determined. Results demonstared that, generally, the M-E effect at corrosion defect caused an increased stress concentration and anodic current density (i.e., corrosion rate), decreasing the failure pressure of the pipeline. The effect became more apparent when the pipe was in suspension. Both the stress and the anodic current density at the corrosion defect were dependent on the defect geometry, especially the defect depth. When the depth was up to 40% of pipe wall thickness, the von Mises stress exceeded the yield stress of the steel, causing local plastic deformation. A critical defect length of <math>20Dt</math> (D is the outer diameter of the pipe and t is pipe wall thickness) existed, below which the von Mises stress and the anodic current density at the corrosion defect increased with increased defect length. When the defect length exceeded the critical value, the effect was not obvious. An increased suspension length of the pipe would elevate the local stress and anodic current density at the corrosion defect, reducing the failure pressure of the pipe. A critical pipe burial depth of 2.5 m was identified, exceeding which the failure pressure of the pipe decreased rapidly with the increased burial depth. When the burial depth was smaller than 2.5 m, the effect was marginal. The location of the corrosion defect on the pipe did not affect the local stress, anodic current density and failure pressure at an appreciable level, and could be ignored in defect assessment on suspended pipelines.

Mismatch effect on safety assessment of pressure pipe with incomplete penetration defect

Safety analysis of pressure piping containing incomplete penetration under combined loads

Research On Safety Assessment Method For Pressure Pipe With Incomplete Welding Defects Under Complicated Loadings

Plastic Limit Load Analysis for Pressure Pipe with Incomplete Welding Defects Based on the Extended Net Section Collapse Criteria

Plastic Limit Load Analysis of Pressure Pipes Containing Incomplete Welding Defects under Combined Loadings

Safety Test Research of Pressure Pipes Containing Incomplete Welding Defects

Strength Differential Effect and Influence of Strength Criterion on Burst Pressure of Thin-Walled Pipelines

Research on root morphology regularization method of incomplete penetration defect in pressure pipe

An Analysis on the Safety Performance of the Combined Fittings of Straight Tees and Long Radius Elbows

Study on safety evaluation method of incomplete penetration welded pipeline under combined loads of internal pressure and bending moment

Study of plastic limit load of the combined fittings of double elbows under in-plane bending moment

Finite Element Analysis on the Mechanical Properties of the Combined Fittings With a Long Radius and Double Elbows

Theoretical Assessment of Burst Failure of Internally Pressurized Defect-Free Pipelines with Plastic Anisotropy

Burst Pressure of Pipelines with Plastic Anisotropy under Combined Internal and External Pressures

Safety assessment of incomplete penetration defects at the root of girth welds in pipelines

Assessment of the interaction of corrosion defects on steel pipelines under combined internal pressure and longitudinal compression using finite element analysis

Verification of Prediction Method of Plastic Collapse Stress for Pipe with Weld Overlay

On the collapse of thick-walled steel pipes under coupling initial geometric imperfection and corrosion defect

Modeling of mechano-electrochemical interaction at a corrosion defect on a suspended gas pipeline and the failure pressure prediction

Interaction between internal and external defects on pipelines and its effect on failure pressure

PLASTIC LIMIT LOAD ANALYSIS OF T-JUNCTIONS OF PIPING WITH LOCAL WALL-THINNINGS UNDER OUT-OF-PLANE MOMENT