Abstract:The centrifugal compressor is widely used for gas compression in various industrial fields such as aero-engine, gas turbine and turbocharger. However, the stable operating range is usually restricted by the occurrence of flow instability such as stall and surge. The paper experimentally examines the developing process of surge and stall occurring in a centrifugal compressor to advance the understanding on flow mechanism of flow instability. It is found that three types of pressure fluctuation can be observed at low flowrate region. At the critical point, the local stall firstly occurs in some specific diffuser passages and the enlarged local diffuser stall eventually induces the mild surge of compression system indicated by the sinusoidal pressure fluctuation. At lower mass flow rate, the diffuser stall cell begins to circumferentially propagate along the impeller rotating direction at 11% of rotor speed with the existence of mild surge. In comparative analysis of IGV pre-swirl angle on the occurrence of mild surge, the mild surge still occurs at the operating condition when the slope of the characteristic map of test stage is still obviously negative, in which the compression system is supposed to be stable in previous study. And a new suggested criterion for the prediction of mild surge is demonstrated that the occurrence of mild surge depends on the destabi-lization effect of downstream components about diffuser and volute. Combined with the experimental data, the streamwise distribution characteristic of diffuser stall can be used to develop the simplified model of lumped parameters for the analysis on the generation mechanism of the diffuser rotating stall. The quantitative investigation on the relation between the pressure-rise characteristic of subcomponents and the occurrence of mild surge and diffuser rotating stall not only advances the prediction of stability limit but also lays the theoretic foundation for controlling these unsteady behaviors to improve the operating range.

Experimental Investigation of the Water–injected Process-Gas Screw Compressor

Experimental investigation of transient characteristics of mild surge and diffuser rotating stall in a centrifugal compressor with vaned diffuser

Experimental Investigation of an Adjustable Ejector for Co2 Heat Pump Water Heaters

EXPERIMENTAL STUDY ON TWO TYPES OF TRANSCRITICAL CO2 HEAT PUMP WATER HEATER SYSTEM

Experimental study and model optimization of thermodynamic performance of a single screw water vapor compressor

Research on heat and mass transfer characteristics of water-sprayed single-screw vapor compressor

Fluid-structure interaction analysis and optimization study of suction valves in small refrigeration compressors

Experimental investigation on working performance of two-stage compression heat pump system with vapor injection

The Design, Selection, and Application of Oil-Injected Screw Compressors for Fuel Gas Service

Performance investigation and design optimization of a vapor injection rotary compressor without check valve in injection path

Theoretical and Experimental Study on Effects of Wet Compression on Centrifugal Compressor Performance

Investigation of the unsteady characteristic in a scroll compressor of a heat pump system for electric vehicles

Theoretical and Experimental Research on Thermal Dynamic Characteristics of Single-Screw Compressor with a New Composite SLIDE valve

Performance investigation and optimization analysis for vapor injection rotary compressor oriented to circular end-plate injection port without check valve

Performance optimization of a heat pump integrated with a single-screw refrigeration compressor with liquid refrigerant injection

Experimental Performance of a Heat Pump Driven by Vapor Injection Linear Compressor

CFD Simulation of a Rotary Compressor with Gas Injection

Improvement on rich gas compression system: direct water-cooling method

On the Stability of Transonic Compressor with Wet Compression and Blade Tip Water Injection

Experiment on Performance of Transcritical CO_2 Heat Pump Water Heater System with Ejector

Study on the Selection of Single-Screw Steam Compressors in Industrial Steam Supply