Abstract:The rotary compressors are currently witnessing a trend towards high-speed operation, resulting in an increased frequency of valve motion and a higher mass flow rate through the discharge valve. Consequently, high-speed operation leads to intensified impact between the valve and both the valve stopper and valve seat, thereby posing challenges to the reliability of the valve. Simultaneously, the dynamic characteristics of the valve at high operating speeds exert a significant influence on the compressor's performance. This paper develops a threedimensional fluid-structure interaction (FSI) model to investigate the dynamic characteristics and reliability of the valve in a high-speed rotary compressor while considering heat transfer during the flow process within the cylinder. The proposed model shows better agreement with the experiment. The study revealed that as the rotational speed increases, there is an obvious rise in over-compression loss and a pronounced valve closure delay, which increases the impact velocity of the valve. The valve experiences two peaks of equivalent stress within one cycle, rendering it susceptible to fail at high speeds. The adoption of a double-valve structure at a rotational speed of 12,000 rpm leads to a significant reduction in over-compression loss by 62.9 %, an increase in volumetric efficiency by 6.7 %, a maximum decrease in impact velocity by 54.5 %, and a maximum decrease in equivalent stress by 25.6 %. The reliability of the double-valve structure under 12,000 rpm was proved by an endurance experiment. Besides, the asymmetry in the opening process of the two valves has been unveiled for the first time.

Fluid-structure interaction analysis and optimization study of suction valves in small refrigeration compressors

Study on Flow Field in Capacity Regulating Actuator for Reciprocating Compressor

Numerical Simulation of the Valve Motion in Automotive Air Conditioning Compressors

FSI Simulation of the Suction Valve on the Piston for Reciprocating Compressors

Numerical and Experimental Investigations on the Failure Mechanism of the Suction Valve in the Refrigerator Compressor under Unconventional Conditions

Investigation of Discharge Valve in Ultra-High-speed Rotary Compressors: an Experimental and FSI Simulation-Based Study

FSI Investigation on the Discharge Valve Lift in a R32 Rotary Compressor and Its Verification

Finite element analysis and topology optimization of direct-drive compressor valve

Performance Improvement of a Centrifugal Compressor by a Variable Low Solidity Diffuser

Fluid–solid Coupling Numerical Simulation for the Performance Prediction and Valve Dynamic Analysis of a Rotary Compressor

Investigation of Flow Behaviour and Heat Rejection for an Air-Cooled Small Multi-Stage Swash-Plate Compressor

Investigation on the Variation of Pressure in the Cylinder of the Refrigerator Compressor Based on FSI Model

Investigation on the Delayed Closure of the Suction Valve in the Refrigerator Compressor by FSI Modeling

Investigation on Thermodynamic State and Valve Dynamics of Reciprocating Compressors with Capacity Regulation System and Parameter Optimization

Mathematical Simulation and Design Optimization of a Novel Swing Vane Compressor

Dynamic numerical investigations of on-board vapor-compression refrigeration system

Modeling the valve dynamics in a reciprocating compressor based on two-dimensional computational fluid dynamic numerical simulation

Theoretical and experimental investigation on the performance of screw refrigeration compressor under part-load conditions

Study of Valve Motion in Reciprocating Refrigerator Compressors Based on the 3-D Fluidâ€“structure Interaction Model

CFD Simulation and Experimental Study of Working Process of Screw Refrigeration Compressor with R134a

Simulation on two-phase refrigerant compression in the cylinder of rotary compressors using CFD method