Abstract:An aerodynamic optimization design process of multistage axial turbine is presented in this article: first, applying quasi-three dimensional (Q3D) design methods to conduct preliminary design and then adopting modern optimization design methods to implement multistage local optimization. Quasi-three dimensional (Q3D) design methods, which mainly refer to S2 flow surface direct problem calculation, adopt the S2 flow surface direct problem calculation program of Harbin Institute of Technology. Multistage local optimization adopts the software of Numeca/Design3D, which jointly adopts genetic algorithm and artificial neural network. The major principle of the methodology is that the successive design evaluation is performed by using an artificial neural network instead of a flow solver and the genetic algorithms may be used in an efficient way. Flow computation applies three-dimensional viscosity Navier?Stokes (N-S) equation solver. Such optimization process has three features: (ⅰ) local optimization based on aerodynamic performance of every cascade; (ⅱ) several times of optimizations being performed to every cascade; and (ⅲ) alternate use of coarse grid and fine grid. Such process was applied to optimize a three-stage axial turbine. During the optimization, blade shape and meridional channel were respectively optimized. Through optimization, the total efficiency increased 1.3% and total power increased 2.4% while total flow rate only slightly changed. Therefore, the total performance was improved and the design objective was achieved. The preliminary design makes use of quasi-three dimensional (Q3D) design methods to achieve most reasonable parameter distribution so as to preliminarily enhance total performance. Then total performance will be further improved by adopting multistage local optimization design. Thus the design objective will be successfully achieved without huge expenditure of manpower and calculation time. Therefore, such optimization design process may be efficiently applied to the aerodynamic design optimization of multistage axial turbine.

Study on S2 Flow Path Design and Three-dimensional Numerical Simulation Parameter Calibration in Axial Compressor

Research on the Flow Path Design Method of Axial Flow Compressor of Gas Turbine

A throughflow-based optimization method for multi-stage axial compressor

Analytic Method for Computing Axial-flow Compressor and Turbine Characteristics

Design and Internal-flow Field Analysis of New Two-stage Centrifugal Compressor

Fluid-structure interaction analysis and optimization study of suction valves in small refrigeration compressors

Development of a Throughflow-Based Simulation Tool for Preliminary Compressor Design Considering Blade Geometry in Gas Turbine Engine

An Aerodynamic Design and Numerical Investigation of Transonic Centrifugal Compressor Stage

Full Annulus Simulation on a Multistage Axial-Centrifugal Combined Compressor

3-D viscous numerical investigation on the overall aerodynamic performance of a transonic axial-flow compressor stage

Calculation of the Overall Aerodynamic Performance of Multi-Stage Axial-Flow Compressor

Three-Dimensional Aerodynamic Optimization Of A Multi-Stage Axial Compressor

Bleed air CFD modelling in aerodynamic simulation of A heavy duty gas turbine compressor

Aerodynamic Analysis and Three-Dimensional Redesign of a Multi-Stage Axial Flow Compressor

Development and application of a throughflow method for high-loaded axial flow compressors

Three-Dimensional Compressor Blading Design Improvements in Low-Speed Model Testing

Development of A Throughflow Method for Aerodynamic Analysis of Highly Loaded Axial Flow Compressors

Study on Aerodynamic Optimization Design Process of Multistage Axial Turbine

A Novel Airfoil Design Method and its Application to the Optimization Design of a 3-Stage Transonic Compressor

A STAGE OF TEST TURBINE DESIGN AND ITS FLOW FIELD ANALYSIS