Abstract:Compared with the globe valves and other on-off valves, cavitation and noise are more severe in the throttle control valve of the refrigerating system due to the higher saturated vapor pressure of the refrigerant. A short tube throttle valve (STTV) is an important throttle control component and cavitation noise easily occurs because of the pressure drop caused by flow throttling. To suppress the cavitation noise, this paper proposed a numerical investigation verified by experimental data into cavitation and noise characteristics inside the STTV. Three kinds of typical throttle valve structures are proposed in this study. The flow field and cavitation noise of the STTV under different refrigerant flow rates were analyzed numerically. The noise levels of the prototype and three optimized structures are comparatively assessed and analyzed. The findings indicate that the level of cavitation noise rises with an increase in flow rate through the STTV. Specifically, when the flow rate transitions from 0.014 kg/s to 0.024 kg/s, there is a corresponding increase in noise levels, moving from 102.8 dB to 122.5 dB. There is less cavitation noise upstream and the flow is stable, while the noise is mainly concentrated downstream with symmetrical distribution characteristics. The distribution seems to have small noise near the internal wall, while large noise is in the center of the downstream in the STTV, and the maximum noise is observed at the corner of the valve seat of the valve outlet. The optimized valve featuring a slope structure on the valve seat significantly reduces cavitation noise, with a maximum noise reduction of 24.94 dB compared to the prototype valve.

Numerical and experimental investigation of cavitation characteristics of the electronic expansion valves

Research on the characteristics of two-phase flow-induced noise in the cavitation dynamics of electronic expansion valves

Flow-induced Noise Mechanism and Optimization Design of Electronic Expansion Valve

INVESTIGATION INTO CAVITATION INDUCED NOISE WITHIN HYDRAULIC RELIEF VALVE

Experiment and numerical simulation of cavitation performance on a pressure-regulating valve with different openings

A Comparative Study on Regulation Methods for Transcritical CO2 Ejector Expansion Refrigeration System.

The CFD Analysis of Cavitation Erosion and Structural Optimization for an Unloading Valve

Simulation Study on Noise Reduction Effect of Porous Material on Electronic Expansion Valve

Numerical Investigation of Cavitation Flow Inside Spool Valve with Large Pressure Drop

Experimental and numerical study on characteristics of super-linear mass flow rate and asymmetric cavitation in novel rotary-baffle curved-channel electronic expansion valve for refrigerator

Flow-induced vibration and noise in control valve

Cavitation and Acoustic Analysis of Sleeve Steam Trap under Multiple Working Conditions

Numerical Study on Flow Characteristics in High Multi-Stage Pressure Reducing Valve

Numerical Investigation Of Methodologies For Cavitation Suppression Inside Globe Valves

Numerical Simulation of Flow-Induced Noise in High Pressure Reducing Valve

Numerical and experimental analysis of cavitation characteristics in safety valves of the nuclear power second circuit using a modified cavitation model

Investigation of Valve Seat Cone Angle on Small Opening Direct-Acting Relief Valve Cavitation Noise

Investigation of the Flow-Induced Noise and Optimization Design of a Short Tube Throttle Valve

Cavitation Effect on Flow Resistance of Sleeve Regulating Valve

Numerical analysis of aerodynamic noise in a high parameter pressure reducing valve

Simulation and Design Improvement of a Low Noise Control Valve in Autonomous Underwater Vehicles