Abstract:The unloading valve is selected as the key part of pressure control and overload protection system in the emulsion pump station (EPS). However, severe cavitation erosion occurs on the inner wall of the valve sleeve located in a downstream outlet, which leads to the performance deterioration, instability, and even failure of the unloading valve. This paper aims to reduce the cavitation phenomenon by optimizing the structure of the spool and improving the streamline direction of the unloading valve. The change in internal structure can reduce cavitation cloud formation along with the internal mechanism of the valve. The working conditions of its flow versus time-dependent data’s are obtained by AMESim, and considered as the boundary condition in Fluent. In addition, the changes in flow behavior and input data’s are analyze and validate before the structural is optimized. After an analysis, the variations in velocities and vapor phase, indicating the higher in pressure drop at its minimum size of valve opening and further consideration for design and development stages. Two innovative structures of valve throttling spool are proposed as a simplified design stage and then carefully curved based on internal geometry to uniformly distribute the velocity vector and streamlines. Subsequently, the post-CFD results reveal the presence of factors affecting properties such as pressure loss, high velocity in the outlets, and concentrated of the vapor volume fraction are decreased under the modified throttling structure and effectively lowers the intensity of cavitation phenomenon.

Numerical Investigation of Cavitation Flow Inside Spool Valve with Large Pressure Drop

The CFD Analysis of Cavitation Erosion and Structural Optimization for an Unloading Valve

Numerical simulation of 3-D turbulent flows in a cut-off valve and analysis of flow characteristics in pipe

Numerical Simulation of Cavitating Flow in Water Hydraulic Axial Piston Pump

An Investigation of the Temperature Distributions Inside A Spool Valve Owing to A Viscous Heating Effect

Noise Properties in Spool Valves with Cavitating Flow

Numerical Study on Viscous Heating of Oil Flow in a Spool Valve

Evaluation of the Viscous Heating Induced Jam Fault of Valve Spool by Fluid–structure Coupled Simulations

Numerical Investigation Of Methodologies For Cavitation Suppression Inside Globe Valves

Numerical Investigation of Cavitating Flow Behind the Cone of a Poppet Valve in Water Hydraulic System

Numerical Study On Temperature Field And Spool Deformation Of Throttle Slide Valve With V-Notches

Numerical Study on the Axial Flow Force of a Spool Valve

The Effect Of Pressure Distribution On High Speed Cavitation Flow Inside Throttling Valve

The Acoustics Of Cavitation In Spool Valve With U-Notches

Numerical Analysis of Flow and Cavitation Characteristics in a Pilot-Control Globe Valve with Different Valve Core Displacements

Cavitation Effect on Flow Resistance of Sleeve Regulating Valve

A Parametric Study of Hydrodynamic Cavitation Inside Globe Valves

Numerical Simulation of the Cavitation Characteristics of A Mixed-Flow Pump

Investigation into pressure distribution of spool value with notches

Numerical and experimental investigation of cavitation characteristics of the electronic expansion valves

INVESTIGATION INTO CAVITATION INDUCED NOISE WITHIN HYDRAULIC RELIEF VALVE