Abstract:The unloading valve is selected as the key part of pressure control and overload protection system in the emulsion pump station (EPS). However, severe cavitation erosion occurs on the inner wall of the valve sleeve located in a downstream outlet, which leads to the performance deterioration, instability, and even failure of the unloading valve. This paper aims to reduce the cavitation phenomenon by optimizing the structure of the spool and improving the streamline direction of the unloading valve. The change in internal structure can reduce cavitation cloud formation along with the internal mechanism of the valve. The working conditions of its flow versus time-dependent data’s are obtained by AMESim, and considered as the boundary condition in Fluent. In addition, the changes in flow behavior and input data’s are analyze and validate before the structural is optimized. After an analysis, the variations in velocities and vapor phase, indicating the higher in pressure drop at its minimum size of valve opening and further consideration for design and development stages. Two innovative structures of valve throttling spool are proposed as a simplified design stage and then carefully curved based on internal geometry to uniformly distribute the velocity vector and streamlines. Subsequently, the post-CFD results reveal the presence of factors affecting properties such as pressure loss, high velocity in the outlets, and concentrated of the vapor volume fraction are decreased under the modified throttling structure and effectively lowers the intensity of cavitation phenomenon.

Investigation into pressure distribution of spool value with notches

Noise Properties in Spool Valves with Cavitating Flow

Numerical Investigation of Cavitation Flow Inside Spool Valve with Large Pressure Drop

An Investigation of the Temperature Distributions Inside A Spool Valve Owing to A Viscous Heating Effect

The Effect Of Pressure Distribution On High Speed Cavitation Flow Inside Throttling Valve

Numerical Study on Viscous Heating of Oil Flow in a Spool Valve

The CFD Analysis of Cavitation Erosion and Structural Optimization for an Unloading Valve

The Acoustics Of Cavitation In Spool Valve With U-Notches

Numerical Study On Temperature Field And Spool Deformation Of Throttle Slide Valve With V-Notches

Numerical Simulation of Flow-Induced Noise in High Pressure Reducing Valve

Flow field simulation and establishment for mathematical models of flow area of spool valve with sloping U-shape notch machined by different methods

Effect of Groove Configurations on Noise Characteristics in Piston Pump

INVESTIGATION INTO CAVITATION INDUCED NOISE WITHIN HYDRAULIC RELIEF VALVE

Effect of Sleeve Orifices Ratio on Flow Performance and Hydrodynamic Noise in the Two-Stage Sleeve Control Valve

Reduced-Order Discharge Area Surrogate Model of Claw-Shaped Notch Hydraulic Spool Valve

Hydraulic flow noise characterization of spool valves using experimental techniques

Experimental and Numerical Investigation of Flow Forces in a Seat Valve Using a Damping Sleeve with Orifices

Cavitation and Acoustic Analysis of Sleeve Steam Trap under Multiple Working Conditions

Numerical simulation and experimental research on the characteristic of pneumatic pressure measurement of spool valve orifice

Experimental Study on the Flow and Vibration Characteristics of Dual Spool Sleeve Valve

Numerical Study on Flow Characteristics in High Multi-Stage Pressure Reducing Valve