Abstract:High-pressure angle valves have suffered from eccentric jet flow characteristic in the diffuser pipe section due to the inherent structures and throttling effect. The eccentric jet flow will continuously scour the valve body and lead to washout on the side wall of the valve seat, largely impacting the valve service life and safety. With regard to this issue, this paper has conducted a numerical characterization study to investigate the influences of valve spool structures including the prototype, parallel and spherical spools on the eccentric jet flow in the first diffuser pipe section of a high-pressure angle valve. Results show that the parallel and spherical valve spool structures can achieve a lower pressure difference across the pipe section than the prototype spool structure, while the spherical spool has shown the minimum pressure difference in the first diffuser pipe section. Moreover, compared with the prototype and parallel spools, separated flows are distributed more uniformly on both side walls in the first diffuser pipe section for the valve with the spherical spool. The relative uniformly distributed separation vortexes makes the high-speed mainstream along the pipe center line and can successfully mitigate the eccentric jet flow. The motivation of this work is to reveal the influencing mechanisms of spool structures on the eccentric jet characteristic in high-pressure angle valves and provide useful guidelines for advanced angle valve design with low erosion and long service life.

Numerical Study on the Axial Flow Force of a Spool Valve

Numerical Investigation of Cavitation Flow Inside Spool Valve with Large Pressure Drop

Numerical simulation of 3-D turbulent flows in a cut-off valve and analysis of flow characteristics in pipe

An Investigation of the Temperature Distributions Inside A Spool Valve Owing to A Viscous Heating Effect

Numerical Study on Viscous Heating of Oil Flow in a Spool Valve

Numerical Study On Temperature Field And Spool Deformation Of Throttle Slide Valve With V-Notches

Unbalanced Force Analysis on Valve Core Clamping in Hydraulic Spool Valves

Numerical Simulation of a Turbulence Flow in the Cut-off Valve by RNG k- ε Turbulence Model

Analysis of flow characteristics in the volute casing of centrifugal pump based on numerical simulation

Evaluation of the Viscous Heating Induced Jam Fault of Valve Spool by Fluid–structure Coupled Simulations

Numerical and Experimental Investigation on Opening Direction Steady Axial Flow Force Compensation of Converged Flow Cartridge Proportional Valve

Reduction of Steady Flow Torques in a Single-Stage Rotary Servo Valve

Structure Optimization of Conical Spool and Flow Force Compensation in a Diverged Flow Cartridge Proportional Valve

Numerical Study of the Fluid Forces for a Whirling Annular Seal: CFD Simulation Versus Experiment

Numerical visualization of flow field in complex passages of periodical fast switch valve

Design and optimization of hydraulic slide valve spool structure based on steady state flow force

Numerical investigations of the influences of valve spool structure on the eccentric jet flow characteristic in high-pressure angle valves

Numerical Simulation of the Gas-Solid Flow Around the Valve of Pneumatic Conveying System

Experimental and Numerical Investigation of Flow Forces in a Seat Valve Using a Damping Sleeve with Orifices

Sleeve Spacing Analysis on Flow Characteristics of Double-Layer Sleeve Control Valve

Study on Flow Field in an Elbow Draft Tube by 3D Numerical Simulation