Abstract:The modern compressor operation is challenged by the liquid presence in wet gas operating conditions. The liquid phase may affect the compressor stability by partially flooding the internal annular gas seals and inducing subsynchronous vibration (SSV). To improve the annular seal behavior and increase the rotor stability, high-precision results of leakage flow rates and rotordynamic force coefficients are needed for annular gas seals in wet gas conditions. In order to better understand the leakage and rotordynamic characteristics of the annular gas seal in wet gas conditions, a 3D transient CFD-based perturbation method was proposed for computations of leakage flow rates and rotordynamic force coefficients of annular gas seals with liquid phase in main gas phase, based on inhomogeneous Eulerian-Eulerian multiphase flow model, mesh deformation technique, and the multifrequency rotor whirling orbit model. Numerical results of frequency-dependent rotordynamic force coefficients and leakage flow rates were presented and compared for three types of noncontact annular gas seals, which include a smooth plain annular seal (SPAS), a labyrinth (LABY) seal, and a fully partitioned pocket damper seal (FPDS). These three seals were designed to have the identical rotor diameter, sealing clearance, and axial length. The accuracy and the availability of the present transient CFD numerical method were demonstrated with the experiment data of leakage flow rates and frequency-dependent rotordynamic force coefficients of the smooth plain seal with four inlet liquid volume fractions (LVFs) of 0%, 2%, 5%, and 8%. Steady and transient numerical simulations were conducted at inlet air pressure of 62.1 bar, pressure ratio of 0.5, rotational speed of 15,000 rpm, and inlet preswirl ratio of 0.3 for four inlet LVFs varying from 0% to 8% and 14 subsynchronous and synchronous whirling frequencies up to 280 Hz. The numerical results show that the inlet liquid phase has a significant influence on the leakage and rotordynamic coefficients for all three types of annular gas seals. The mixture leakage flow rate increases with the increasing inlet LVF, combining the decreasing gas-phase and linearly increasing liquid-phase leakage flow rates. The smooth plain seal leaks the most gas phase and liquid phase, followed by the pocket damper seal (PDS) and then the labyrinth seal. Increasing inlet LVF significantly decreases the direct stiffness and slightly increases the effective damping of the smooth plain seal. The labyrinth seal possesses evident negative direct stiffness and shows a noticeable decreasing effective damping with the increasing inlet LVF at the subsynchronous frequency range. Increasing inlet LVF obviously increases all the force coefficients of the pocket damper seal including the positive effective damping. From a rotordynamic viewpoint, the FPDS possesses a better liquid tolerant capability and so is a better sealing scheme for the balance piston seals and center seals of the centrifugal compressor in wet gas operating condition.

Numerical Study of the Fluid Forces for a Whirling Annular Seal: CFD Simulation Versus Experiment

Numerical Simulation on Rotordynamic Characteristics of Annular Seal under Uniform and Non-Uniform Flows

A New Transient CFD Method for Determining the Dynamic Coefficients of Liquid Annular Seals

Numerical Calculation of Nonlinear Dynamic Characteristics for Labyrinth Seals

Analysis of flow characteristics in the volute casing of centrifugal pump based on numerical simulation

Numerical simulation of flow and heat transfer in journal bearing lubrication

Fluid-structure interaction analysis on turbulent annular seals of centrifugal pumps during transient process

Transient CFD Simulation on Dynamic Characteristics of Annular Seal under Large Eccentricities and Disturbances

Numerical Comparison of Static and Rotordynamic Characteristics for a Grooved-Stator/Smooth-Rotor and a Smooth-Stator/Grooved-Rotor Liquid Annular Seals

Fluid-structure interaction analysis of annular seals and rotor systems in multi-stage pumps

Study of annular seal flow inlet-loss coefficient and its influence on rotor system vibration characteristic

Studies of Exit Pressure Recovery Coefficient and Its Effects on Dynamic Characteristics of Annular Water Seals

Numerical Investigation on the Leakage and Rotordynamic Characteristics for Three Types of Annular Gas Seals in Wet Gas Conditions

Study on Influence Factors of Tangential Fluid-induced Force and Radial Fluid-induced Force in Seals

Dynamic coefficients of small cone-shaped annular seal rotor

Three-Dimensional Coupling Analysis of Flow and Thermal Performance of A Mechanical Seal

INFLUENCES OF LIQUID-SEAL INLET SWIRL RATIO ON THE DYNAMIC PROPERTIES OF A ROTOR SYSTEM

A Comparison of Static and Rotordynamic Characteristics for Two Types of Liquid Annular Seals With Parallelly Grooved Stator/Rotor

Numerical Analysis of the Rotordynamic Coefficients for Annular Gas Seals

Numerical Analysis of Heat Transfer Coefficient in Mechanical Face Seals

Numerical Analysis and Experiment Study of Magnetic Fluid Boundary in Seals