Abstract:Among the manganese -based lithium -ion sieves, Li 1.6 Mn 1.6 O 4 has a high theoretical lithium adsorption capacity as a spinel ion sieve material. Small particle size orthogonal phase purity LiMnO 2 powders were prepared by a semi -wet method and calcined in air at 400 degrees C to obtain Li 1.6 Mn 1.6 O 4 a lithium -ion sieve precursor. The synergistic effects of oxygen atmosphere, heat treatment conditions and lithium/manganese molar ratio on the crystal structure of LiMnO 2 and the lithium adsorption/desorption characteristics of Li 1.6 Mn 1.6 O 4 were comprehensively investigated with XRD, SEM, TEM, XPS, Raman, DTA-TG and capacity retention study. Notably, when the initial lithium/manganese molar ratio was set at 1.1, and the sample underwent a calcination at 120 degrees C for 48 h under carefully controlled deoxygenation conditions, we observed the exclusive presence of the desired orthorhombic phase in the LiMnO 2 sample. In contrast, when the synthesis conditions deviated from the optimized parameters led to the presence of the monoclinic phase of Li 2 MnO 3 . This highlights the sensitivity of Li 1.6 Mn 1.6 O 4 properties to the synthesis conditions. The results of adsorption -desorption cycles show that the ion sieve Li 1.6 Mn 1.6 O 4 prepared by heat treatment of ordered o-LiMnO 2 is more stable, the structural stability of Li 1.6 Mn 1.6 O 4 were characterized by high -temperature in -situ XRD experiments during heating from 30 to 800 degrees C. The equilibrium adsorption capacity was 34 mg g -1 in Qarhan Salt Lake brine at 10th cycle, and a remarkably low Mn dissolution loss rate of 0.6 %. The results have significant potential to advance the development of highperformance adsorbent in the Li-Mn-O system and contribute to the advances in lithium separation technology.

Direct Hydrothermal Synthesis of LiMn 2 O 4 Spinel and Lithium Ion Selective Adsorption

Direct hydrothermal synthesis of ternary Li-Mn-O oxide ion-sieves

LIMN2O4 SPINEL DIRECT SYNTHESIS AND LITHIUM ION SELECTIVE ADSORPTION

Hydrothermal Synthesis and Lithium Adsorption Properties of LiMn_2O_4 Spinel

Preparation and Lithium Adsorption Properties of Low-Dimensional Cubic Li4mn5o12 Nanostructure

Lithium Selective Adsorption on 1-D MnO2 Nanostructure Ion-Sieve

Synthesis and Electrochemical Properties of Nanostructured LiMn2O4 for Lithium-Ion Batteries

Synthesis and properties of lithium ion-sieve precursor Li 4 Mn 5 O 12

Preparation of Submicrocrystal LiMn2O4 Used Mn3O4 As Precursor and Its Electrochemical Performance for Lithium Ion Battery

Synthesis and Adsorption Properties of Li1.6mn1.6o4 Spinel

Preparation and Li + extraction/adsorption properties of lithium-rich manganese oxide in aqueous solution

Synthesis of spinel LiMn2O4 nanoparticles through one-step hydrothermal reaction

Lithium extraction/insertion process on cubic Li-Mn-O precursors with different Li/Mn ratio and morphology

Synthesis and Adsorption Properties of Li1.6Mn1.6O4 by a Combination of Redox Precipitation and Solid-Phase Reaction

Practical synthesis of manganese oxide MnO2·0.5H2O for an advanced and applicable lithium ion-sieve

Microwave assisted hydrothermal synthesis of MnO2·0.5H2O ion-sieve for lithium ion selective adsorption

Lithium Ion Adsorption–desorption Properties on Spinel Li4Mn5O12 and Ph-Dependent Ion-Exchange Model

Low-temperature synthesis of highly crystallized LiMn2O4 from alpha manganese dioxide nanorods

Synthesis, Characterization And Property Of Nanooxide Lithium Ion-Sieve

One-Step, Low-Temperature Route for the Preparation of Spinel Limn2o4 As A Cathode Material for Rechargeable Lithium Batteries

Semi-wet Synthesis of High-Performance Li1.6Mn1.6O4 for Selective Lithium Extraction from Salt Lakes Brine