Abstract:Three-dimensionally ordered macroporous spinel lithium manganese oxide Li1.6Mn1.6O4 was fabricated directly by polymethyl methacrylate colloidal crystal template filled with the LiNO3, Mn(Ac)(2)center dot 4H(2)O and citric acid mixed solution and oxidation roasting in the air atmosphere. After the precursor was delithiated by 0.1 mol/L hydrochloric acid, three-dimensionally ordered macroporous lithium ion-sieve was obtained, whose macroporous diameter and pore wall thickness were about 240 and 50 nm, respectively. The X-ray diffraction results show that Li1.6Mn1.6O4, lithium ion-sieve and the lithium-adsorbed samples all keep spinel structure. The three-dimensionally ordered macroporous (3DOM) materials present the channel space connecting each other, which shortens the adsorption equilibrium time of Li+. The delithiation rate of precursor gets 95% at 80 degrees C, while the solution loss rates of manganese are less than 2.5% below 60 degrees C. Solution temperature has great influence on the exchange ability of Li+, raising temperature leads to the increase of Li+ and H+ reversible exchange degree, the Li+ maximum adsorption capacity is 56.7 mg/g, but the hydrogens in the manganese 16d octahedral defect position are difficult to be exchanged. The analyses of pH titration and distribution coefficient K-d indicate that the solid acid has a high selectivity of Li+ in the coexisting solution of Li+, Na+ and K+.

Hydrothermal Synthesis and Lithium Adsorption Properties of LiMn_2O_4 Spinel

Direct Hydrothermal Synthesis of LiMn 2 O 4 Spinel and Lithium Ion Selective Adsorption

LIMN2O4 SPINEL DIRECT SYNTHESIS AND LITHIUM ION SELECTIVE ADSORPTION

Preparation and Lithium Adsorption Properties of Low-Dimensional Cubic Li4mn5o12 Nanostructure

Direct hydrothermal synthesis of ternary Li-Mn-O oxide ion-sieves

Lithium Selective Adsorption on 1-D MnO2 Nanostructure Ion-Sieve

Synthesis and Adsorption Properties of Li1.6mn1.6o4 Spinel

Synthesis and Electrochemical Properties of Nanostructured LiMn2O4 for Lithium-Ion Batteries

Preparation and Li + extraction/adsorption properties of lithium-rich manganese oxide in aqueous solution

Synthesis and properties of lithium ion-sieve precursor Li 4 Mn 5 O 12

Preparation of Submicrocrystal LiMn2O4 Used Mn3O4 As Precursor and Its Electrochemical Performance for Lithium Ion Battery

Lithium adsorption on nanocrystalline MnO2 ion sieve

Adsorption of lithium ions on novel nanocrystal MnO2

Lithium Ion Adsorption–desorption Properties on Spinel Li4Mn5O12 and Ph-Dependent Ion-Exchange Model

Synthesis of spinel LiMn2O4 nanoparticles through one-step hydrothermal reaction

Preparation of Three-Dimensionally Ordered Macroporous Spinel Li1.6mn1.6o4 and Adsorption Characteristics of Lithium Ion-Sieve

Synthesis and Adsorption Properties of Li1.6Mn1.6O4 by a Combination of Redox Precipitation and Solid-Phase Reaction

Practical synthesis of manganese oxide MnO2·0.5H2O for an advanced and applicable lithium ion-sieve

Synthesis and Electrochemical Performance of Spinel-Type LiMn2O4 Using Γ-Mnooh Rods As Self-Template for Lithium Ion Battery

Preparation and adsorption property of spinel-type lithium ion-sieve

Synthesis and Electrochemical Properties of LiMn2O4 Spinel Phase with Nanostructure