Abstract:Accidents of launch vehicles, satellites, and missiles originating from remainder particles account for 6% of the causes in accident investigations. The problem of remainder particles seriously reduces the reliability of sealed electronic components in aerospace. Numerous cases have shown that remainder particles cannot be completely avoided due to process, environment, and other factors. As an important method for detecting remainder particles, the particle impact noise detection (PIND) method has become a standard testing tool in the aerospace field in China. However, there is still a lack of effective and feasible solutions to the problems of sensor sensitivity measurement and consistency evaluation, which are key and indispensable components of the closed-loop process of the PIND method. Through numerous experiments, this article proposed a complete set of new methods and systems for the sensitivity measurement of PIND sensors, allowing real-time measurement of PIND sensor sensitivity at the production site without moving or disassembling the sensor. This article systematically illustrated the feasibility of this new method and system from the perspective of measurement method, measurement system, measurement result verification, and measurement system application. The accuracy and feasibility of the proposed method were verified using the free-field underwater comparison method. The average difference between the two methods was less than 1 dB (1 V/ bar), which meets the practical requirements (±3 dB). In addition, the coupling effect of different coupling agents, the full contact time of coupling agents, and the epoxy adhesive bonding process were further analyzed based on the proposed method and system, and satisfactory improvement results were obtained.

Analysis on Remainder Activation Effect of PIND Impact Test Conditions for Sealed Relay

Partial discharge diagnosis by simultaneous observation of discharge pulses and vibration signal

Research and Application of a Novel Sensitivity Measurement Method for Particle Impact Noise Detection Sensors

Design & implementation of an anti-interference residual current circuit breaker IC

Realization and Test of the Energy Directional Protection

Analysis on Relay Pretection Actions of 7.20 Failure of Xindian Substation

Analysis and Rejection of Noises from Partial Discharge (PD) On-Site Testing Environment

The Influence of Concentration and Size on the Error of Particulate Matter Detection Using Charge Induction Method

Disturbance Rejection Degree and Countermeasures to the Disturbance of Electric Fast Transient Pulse Caused by Relays

NOISE EVALUATION BASED ADAPTIVE FAST DISTANCE RELAY PROTECTION

A Method for Weak Impact Signal Discrimination Based on Para-Approximate Entropy

Performance analysis of multiphase compensated distance relay in single-phase-to-ground fault with power swing

Transient Thermal Analysis of Sealed Electromechanical Relay in Repeated Short-Term Operation System

ANALYSIS OF PERFORMANCE FOR SURGE IMPEDANCE RELAY

Evaluation of Single Event Upset on a Relay Protection Device

A Novel Approach to Partial Discharge Detection Under Repetitive Unipolar Impulsive Voltage

Research on the influence and test of core components on relay protection device

Performance Testing and Analysis of Multi-vendor IEDs under PRP Configuration

Pulse Quantitative Determination in Partial Discharge Detection Using Wide Bandwidth Pulse Current Method

Research on a synchronised classification method for loose particle detection signals of aerospace- sealed electronic components

Achievement of Polarization and Depolarization Current Tests for Condition Estimation of Oil-paper Insulation Using LabVIEW