Abstract:With the advancement of semiconductor manufacturing technology, thin film structures were widely used in MEMS devices. These films played critical roles in providing support, reinforcement, and insulation in MEMS devices. However, due to their microscopic dimensions, the sensitivity of their parameters and performance to thermal stress increased significantly. In this study, a Pirani gauge sample with a multilayer thin film structure was designed and fabricated. Based on this sample, finite element modeling analysis and thermal stress experiments were conducted. The finite element modeling analysis employed a combination of steady-state and transient methods to simulate the deformation and stress distribution of the device at room temperature (25 °C), low temperature (−55 °C), and high temperature (125 °C). The thermal stress test involved placing the sample in a temperature cycling chamber for temperature cycling tests. After the tests, the resonant frequency and surface deformation of the device were measured to quantitatively evaluate the impact of thermal stress on the deformation and resonant frequency parameters of the device. After the experiments, it was found that the clamped-end beams made of Pt were a stress concentration area. Additionally, the repetitive thermal load caused the cantilever beam to move cyclically in the Z direction. This movement altered the deformation of the film and the resonant frequency. The suspended film exhibited concavity, and the overall trend of the resonant frequency was downward. Over time, this could even lead to the fracture of the clamped-end beams. The variation of mechanical parameters derived from finite element simulations and experiments provided an important reference value for device design improvement and played a crucial role in enhancing the reliability of thin film devices.

Design of a Test Structure Based on Chevron-Shaped Thermal Actuator for In-Situ Measurement of the Fracture Strength of MEMS Thin Films

A Thermal Actuated Test Platform for in Situ Evaluating the Tensile Fracture Strength of Micro-Structures

A Universal Structure for Self-Aligned in Situ On-Chip Micro Tensile Fracture Strength Test

An integrated push-to-pull micromechanical device: Design, fabrication, and in-situ experiment

OS5-2-3 an In-Situ Micro-Tension Setup and Its Application

A Novel Approach to Study Patterned Thin Film Local Stress for Microelectronics Application

Monotonic and fatigue testing of spring-bridged freestanding microbeams application for MEMS

Technique and Structure for Testing Bonding Intension in Micron Scale

Fracture Properties of MEMS/NEMS Thin Films

A Measuring System for Mechanical Characterization of Thin Films Based on a Compactin Situmicro-Tensile Tester and SEM Moiré Method

Improvement Of Thin Film Tensile Testing Technology Using Process Integrated Specimen And Considering Its Out-Of-Plane Deformation

Structural Optimization and Mechanical Simulation of MEMS Thin-Film Getter–Heater Unit

A Novel Micro Tensile Testing Instrument with Replaceable Testing Specimen by Parylene Passivation Technique

Design and Development of Novel Electroplating Spring Frame Mems Structure Specimens for the Microtensile Testing of Thin Film Materials

A Dual-Parameter On-Chip Test Platform Based on Thermal Actuator for Testing Fracture Strength of Microstructure

Recent Efforts in Modelling Combined Rate, Size and Thermal Effects on Single Crystal Strength

An On-Chip Bistable Structure for Extracting the Impact Fracture Strength of the Microstructure

In Situ and Real-Time Tensile Testing of Thin Films Using Double-Field-of-view Electronic Speckle Pattern Interferometry

A New Test Structure To Measure Bonding Strength In Micro-Bonding Area

A new in situ residual stress measurement method for a MEMS thin fixed-fixed beam structure

Variation of MEMS Thin Film Device Parameters under the Influence of Thermal Stresses