Abstract:As the enhanced acceleration performance of electric vehicles demands improved mileage capabilities, 3D packaging is a promising solution for developing high-power-density SiC power modules. However, 3D pack-aging causes instability owing to the increased heat flux and heat dissipation inside the power module. Thus, this paper proposes an ultra-thermostable embedded liquid cooling strategy for the thermal management of SiC 3D packaging power modules in electric vehicles. We constructed an embedded micro pin-fin (E-MPF) with non-uniform density in the SiC substrate to mount the SiC Schottky barrier diodes (SBDs). The thermostability and temperature uniformity of the SiC 3D packaging power modules containing E-MPF SiC and direct bond copper (DBC) substrates were verified. The results revealed that the SiC SBDs mounted on the E-MPF SiC substrate could stably operate up to a total power dissipation of 320 W at a 100 mL/min coolant (water) flow rate, whereas those attached on the DBC substrate could be operated only under 144 W (operation terminated at a maximum junction temperature of 175 celcius). Furthermore, the junction-to-coolant thermal resistance of the E-MPF SiC substrate could be reduced by 78.89 % compared to that of the DBC substrate. Moreover, the prepared 3D stacking package effectively improved the temperature uniformity of the SiC power modules by 68.69 %. The presented ultra-thermostable E-MPF substrate SiC power module can steadily render a motor torque elevation that is one magnitude greater than that required for sustaining the boiling-free condition on the DBC substrate. This embedded liquid-cooling architecture affords a feasible solution for the thermal management of upcoming high-power electric vehicle SiC inverters.

A Busbar Integrated Sic-Based Converter With Embedded Heat-Pipes

Compact Sandwiched Press-Pack SiC Power Module With Low Stray Inductance and Balanced Thermal Stress

Structural Design of A Five-Level Hybrid Active Npc Converter for High Power Density Motor Drives

Analytical Modeling of Forced-Air Cooling Heatsink by Considering Air Temperature Rise in Channel and Coupling of Multiple Heat Sources

A Solution to Press-Pack Packaging of SiC MOSFETS

Elastic Half-Space Theory-Based Distributed-Press-Pack Packaging Technology for Power Module with Balanced Thermal Stress

Analysis of Novel Packaging Techniques for High Power Electronics in SiC

High Temperature Direct Double Side Cooled Inverter Module for Hybrid Electric Vehicle Application

Direct Integration of Optimized Phase-Change Heat Spreaders Into SiC Power Module for Thermal Performance Improvements Under High Heat Flux

Ultra-thermostable Embedded Liquid Cooling in SiC 3D Packaging Power Modules of Electric Vehicles

Embedded heat pipe SiC interposer for distributed power devices

Design and evaluation of press-pack SiC MOSFET

High performance cooling system for automotive inverters

Stacked power module with integrated thermal management

Investigation of Vehicle-Oriented Double-Sided Cooling Power Module With BGA Technology

Busbar Optimization Design for High Power Converters

Design of Heat Sink for Electric Vehicle SiC MOSFET Air-cooled Inverter

Compact-Interleaved Packaging Method of Power Module With Dynamic Characterization of 4H-SiC MOSFET and Development of Power Electronic Converter at Extremely High Junction Temperature

Integrated Manifold Microchannels and Near-Junction Cooling for Enhanced Thermal Management in 3D Heterogeneous Packaging Technology

Design Method for Multichip Double-Sided Cooling Power Module with Multidimensional Self-and Mutual Inductances

Thermal Performance And Reliability Management For Novel Power Electronic Packaging Using Integrated Base Plate