Abstract:Microelectromechanical systems (MEMS) technologies are developing rapidly with increasing study of the design, fabrication and commercialization of microscale systems and devices. Accurate knowledge on the mechanical behaviors of thin film materials used for MEMS is important for successful design and development of MEMS. Here a novel electroplating spring-bridge micro-tensile specimen integrates pin-pin align holes, misalignment compensate spring, load sensor beam and freestanding thin film is demonstrated and fabricated. The specimen is fit into a specially designed micro-mechanical apparatus to carry out a series of monotonic tensile testing on sub-micron freestanding thin films. Certain thin films applicable as structure or motion gears in MEMS were tested including sputtered gold, copper and tantalum nitride thin films. Metal specimens were fabricated by sputtering; for tantalum nitride film samples, nitrogen gas was introduced into the chamber during sputtering tantalum films on the silicon wafer. The sample fabrication method involves three steps of lithography and two steps of electroplating copper to hold a dog bone freestanding thin film. Using standard wet etching or lift off techniques, a series of microtensile specimens were patterned in metal thin films, holes, and seed layer for spring and frame structure on the underlying silicon oxide coated silicon substrate. Two steps of electroplating processing to distinct spring and frame portion of the test chip. Finally, chemical etched away the silicon oxide to separated electroplated specimen and silicon substrate.

MEMS Micro-Bridge Structure-Based Process Platform Fabricated with CMOS Al BEOL Compatible Process

Process Development of A New Tgv Interposer for Wafer Level Package of Inertial Mems Device

Simulation and Fabrication of SiO2-based Piezoresistive Microbridges for Chem/biosensors

Post-CMOS Process for High-Aspect-ratio Monolithically Integrated Single Crystal Silicon Microstructures

Microdevice Array Design and Fabrication in Monolithic MEMS SoC

Design and fabrication of MEMS devices using the integration of MUMPs, trench-refilled molding, DRIE and bulk silicon etching processes

Monolithic Mems Soc Design And Fabrication Using 0.35 Mu M Bcd Technology

Study on Compatible Cmos-Mems Process with Surface Micromachining for the Application of Monolithic Integration

A CMOS Compatible Process for Monolithic Integration of High-Aspect-ratio Bulk Silicon Microstructures

Process-Induced Stress and Hydrogen Effects on Monolithic Integrated CMOS-MEMS Micro-Bimaterial Cantilever Sensor Array

A molded surface-micromachining and bulk etching release (MOSBE) fabrication platform on (1 1 1) Si for MOEMS

Monotonic and fatigue testing of spring-bridged freestanding microbeams application for MEMS

Process-induced stress and hydrogen effects on monolithic integrated BiCMOS-MEMS resonators

Post-CMOS Processing for High-Aspect-Ratio

Optimization of Thin Metal Layer Etch Process for MEMS/Sensor Application*

The Hybrid Fabrication Process of Metal/Silicon Composite Structure for MEMS S&A Device.

DESIGN OF MICROBOLOMETER BY POLYCRYSTALLINE SILICON IN STANDARD CMOS TECHNOLOGY

Fabrication of monolithic integrated bimaterial resonant uncooled IR sensor

Monolithic Integration of a Wafer-Level Thin-Film Encapsulated mm-Wave RF-MEMS Switch in BEOL of a 130-nm SiGe BiCMOS Technology

A Generalized Cmos-Mems Platform For Micromechanical Resonators Monolithically Integrated With Circuits