Abstract:The micro-electro-mechanical system (MEMS) resonator developed based on surface processing technology usually changes the section shape either due to excessive etching or insufficient etching. In this paper, a section parameter is proposed to describe the microbeam changes in the upper and lower sections. The effect of section change on the mechanical properties is studied analytically and verified through numerical and finite element solutions. A doubly-clamped microbeam-based resonator, which is actuated by an electrode on one side, is investigated. The higher-order model is derived without neglecting the effects of neutral plane stretching and electrostatic nonlinearity. Further, the Galerkin method and Newton⁻Cotes method are used to reduce the complexity and order of the derived model. First of all, the influence of microbeam shape and gap variation on the static pull-in are studied. Then, the dynamic analysis of the system is investigated. The method of multiple scales (MMS) is applied to determine the response of the system for small amplitude vibrations. The relationship between the microbeam shape and the frequency response is discussed. Results show that the change of section and gap distance can make the vibration soften, harden, and so on. Furthermore, when the amplitude of vibration is large, the frequency response softening effect is weakened by the MMS. If the nonlinearity shows hardening-type behavior at the beginning, with the increase of the amplitude, the frequency response will shift from hardening to softening behavior. The large amplitude in-well motions are studied to investigate the transitions between hardening and softening behaviors. Finally, the finite element analysis using COMSOL software (COMSOL Inc., Stockholm, Sweden) is carried out to verify the theoretical results, and the two results are very close to each other in the stable region.

Process-induced stress and hydrogen effects on monolithic integrated BiCMOS-MEMS resonators

Process-Induced Stress and Hydrogen Effects on Monolithic Integrated CMOS-MEMS Micro-Bimaterial Cantilever Sensor Array

Inter-CMOS process for monolithic integrated MEMS resonator

Study on Compatible Cmos-Mems Process with Surface Micromachining for the Application of Monolithic Integration

Fabrication of monolithic integrated bimaterial resonant uncooled IR sensor

A CMOS Compatible Process for Monolithic Integration of High-Aspect-ratio Bulk Silicon Microstructures

Post-CMOS Process for High-Aspect-ratio Monolithically Integrated Single Crystal Silicon Microstructures

Fabrication of Monolithic Integrated MEMS Resonator with Wet-Release-monitoring Array

Microdevice Array Design and Fabrication in Monolithic MEMS SoC

CMOS MEMS: A Key Technology Towards the &#x201c;more Than Moore&#x201D; Era

Suspended Gate Field Effect Transistor Type Microelectromechanical Systems Resonators Modelling with Micro-Raman Spectroscopy Measured Residual Stress

A Generalized Cmos-Mems Platform For Micromechanical Resonators Monolithically Integrated With Circuits

Soft chemistry assisted On-chip Integration of Nanostructured quartz-based Piezoelectric Microelectromechanical System

Interface Stress for Bidirectional Frequency Tuning of Prebuckled Vanadium Dioxide MEMS Resonators

Design and fabrication of MEMS devices using the integration of MUMPs, trench-refilled molding, DRIE and bulk silicon etching processes

Monolithic Mems Soc Design And Fabrication Using 0.35 Mu M Bcd Technology

Design of High-Sensitivity Cantilever and Its Monolithic Integration with CMOS Circuits

Static and Dynamic Mechanical Behaviors of Electrostatic MEMS Resonator with Surface Processing Error

Realization of Three-Dimensionally MEMS Stacked Comb Structures for Microactuators Using Low-Temperature Multi-Wafer Bonding with Self-Alignment Techniques in CMOS-Compatible Processes

IC Simulations of the On-chip Integration for SOI CMOS and MEMS