Abstract:InGaN-based materials and structures have attracted extensive attention in developing green light-emitting diodes (LEDs), but the fabrication of high-performance low-dimensional green LEDs is seriously limited to the sample preparation, device construction, green gap, and efficiency droop. In this work, a kind of green LED composed of p-type InGaN layers and a one-dimensional wired ZnO via Ga incorporation, featuring a green wavelength of 520.0 nm and a linewidth of about 34.0 nm, was designed. The LED characteristics, with respect to the peak wavelengths and linewidths, are almost constant at different input currents, indicating the insensibility to the quantum-confined Stark effect commonly observed in InGaN-based light sources. The color coordinate is really close to pure green (0.170, 0.797) of the Rec. 2020 standard. Significantly, the efficiency droop in the fabricated LED is temperate, suggesting that the recombination of carriers can occur toward the n-ZnO:Ga/p-InGaN interface instead of the p-InGaN region. With an increase in Ga-doping concentration in ZnO:Ga wires, the main EL peaks show a significant red shift from 520 to 584 nm in the green and yellow emission spectrum. This wavelength-tuning is further confirmed by the successfully varied color coordinates. The fabrication of one-dimensional wired green LEDs not only can break through the green gap but also can work as a potential candidate to developing solid-state lighting in the visible band for a wide range of practical applications.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acsanm.1c02650.Device preparation process of the n-ZnO:Ga MW/p-InGaN heterojunction green light sources; LED characterization of the as-constructed emission devices, with the wire having different sizes and surface morphologies; EL spectra of the as-constructed LEDs and their corresponding relative EQE in which the wires were selected from different samples (PDF)This article has not yet been cited by other publications.

Homogeneous ZnO nanowire arrays p-n junction for blue light-emitting diode applications.

Ordered nanowire array blue/near-UV light emitting diodes.

Enhancing Light Emission of Zno Microwire-Based Diodes by Piezo-Phototronic Effect

White Light‐Emitting Diode From Sb‐Doped p‐ZnO Nanowire Arrays/n‐GaN Film

Fabrication of a High‐Brightness Blue‐Light‐Emitting Diode Using a ZnO‐Nanowire Array Grown on P‐gan Thin Film

Near UV LEDs Made with in Situ Doped P-N Homojunction ZnO Nanowire Arrays

Recent progress in ZnO-based heterojunction ultraviolet light-emitting devices

Room Temperature Blue-UV Electroluminescence from ZnO Light-Emitting Diodes Involving Na-Doped P-Type ZnO and ZnO/ZnMgO Multi-Quantum Wells

Fe‐Doped P‐zno Nanostructures/n‐GaN Heterojunction for “blue‐free” Orange Light‐Emitting Diodes

Electroluminescence from ZnO Nanowires with a P-Zno Film/n-Zno Nanowire Homojunction

Full‐Color Electroluminescence from ZnO‐Nanoparticles‐based Homojunction Diodes

High-performance Ultraviolet-Blue Light-Emitting Diodes Based on an N-Zno Nanowall Networks/p-Gan Heterojunction

ZnO single microwire homojunction light emitting diode grown by electric field assisted chemical vapor deposition

Facile fabrication of nano-scale ZnO p-n junction and its blue electroluminescence

Wavelength-Tunable Green Light Sources Based on ZnO:Ga Nanowire/p-InGaN Heterojunctions

High-Performance Ultraviolet Light-Emitting Diodes Using N-Zno/p-hbn/p-gan Contact Heterojunctions.

Low-voltage blue light emission from n-ZnO/p-GaN heterojunction formed by RF magnetron sputtering method

Blue-Yellow Zno Homostructural Light-Emitting Diode Realized By Metalorganic Chemical Vapor Deposition Technique

Room Temperature P-N ZnO Blue-Violet Light-Emitting Diodes

Fabrication of a High-Brightness BlueLight-Emitting Diode Using a ZnO-Nanowire Array Grown on p-GaN Thin Film C A T IO

Zinc Oxide for White Light Emitting Diode