Abstract:InGaN-based materials and structures have attracted extensive attention in developing green light-emitting diodes (LEDs), but the fabrication of high-performance low-dimensional green LEDs is seriously limited to the sample preparation, device construction, green gap, and efficiency droop. In this work, a kind of green LED composed of p-type InGaN layers and a one-dimensional wired ZnO via Ga incorporation, featuring a green wavelength of 520.0 nm and a linewidth of about 34.0 nm, was designed. The LED characteristics, with respect to the peak wavelengths and linewidths, are almost constant at different input currents, indicating the insensibility to the quantum-confined Stark effect commonly observed in InGaN-based light sources. The color coordinate is really close to pure green (0.170, 0.797) of the Rec. 2020 standard. Significantly, the efficiency droop in the fabricated LED is temperate, suggesting that the recombination of carriers can occur toward the n-ZnO:Ga/p-InGaN interface instead of the p-InGaN region. With an increase in Ga-doping concentration in ZnO:Ga wires, the main EL peaks show a significant red shift from 520 to 584 nm in the green and yellow emission spectrum. This wavelength-tuning is further confirmed by the successfully varied color coordinates. The fabrication of one-dimensional wired green LEDs not only can break through the green gap but also can work as a potential candidate to developing solid-state lighting in the visible band for a wide range of practical applications.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acsanm.1c02650.Device preparation process of the n-ZnO:Ga MW/p-InGaN heterojunction green light sources; LED characterization of the as-constructed emission devices, with the wire having different sizes and surface morphologies; EL spectra of the as-constructed LEDs and their corresponding relative EQE in which the wires were selected from different samples (PDF)This article has not yet been cited by other publications.

Full‐Color Electroluminescence from ZnO‐Nanoparticles‐based Homojunction Diodes

Largely Enhanced Efficiency In Zno Nanowire/P-Polymer Hybridized Inorganic/Organic Ultraviolet Light-Emitting Diode By Piezo-Phototronic Effect

Enhancing Light Emission of Zno Microwire-Based Diodes by Piezo-Phototronic Effect

Near UV LEDs Made with in Situ Doped P-N Homojunction ZnO Nanowire Arrays

Recent progress in ZnO-based heterojunction ultraviolet light-emitting devices

Electroluminescence from ZnO Nanowires with a P-Zno Film/n-Zno Nanowire Homojunction

Electroluminescence from ZnO/n<sup>+</sup>-Si Heterojunction

Van der Waals contacted MoO x staked ZnO/GaN vertical heterostructured ultraviolet light emitting diodes.

The fabrication of white light-emitting diodes using the n-ZnO/NiO/p-GaN heterojunction with enhanced luminescence

Electroluminescence from Light-Emitting Devices Based on Erbium-Doped ZnO/n-Si Heterostructures: Enhancement Effect of Fluorine Co-Doping

Blue-Yellow Zno Homostructural Light-Emitting Diode Realized By Metalorganic Chemical Vapor Deposition Technique

Ultraviolet Electroluminescence from Zno/P-Si Heterojunctions

Surface Plasmon Enhanced Graphene/P-Gan Heterostructure Light-Emitting Diode by Ag Nano-Particles

Ultraviolet and Visible Electroluminescence from N-Zno∕siox∕(n,p)-si Heterostructured Light-Emitting Diodes

Progress in Violet Light-Emitting Diodes Based on ZnO/GaN Heterojunction

ZnO Light-Emitting Diodes Fabricated on Si Substrates with Homobuffer Layers

Fabrication of a High‐Brightness Blue‐Light‐Emitting Diode Using a ZnO‐Nanowire Array Grown on P‐gan Thin Film

Enhancement of external quantum efficiency and quality of heterojunction white LEDs by varying the size of ZnO nanorods

Improved light emission from n-ZnO/p-Si heterojunction with HfO2 as an electron blocking layer

Wavelength-Tunable Green Light Sources Based on ZnO:Ga Nanowire/p-InGaN Heterojunctions

Fabrication and emission properties of a n-ZnO/p-GaN heterojunction light-emitting diode