Abstract:A thermal wind sensor utilizes the fact that airflow over a heated plate will cool it asymmetrically, with the upstream part of the plate being cooled more than the downstream part. In the temperature-balanced (TB) mode, the heating power may be distributed spatially in the sensor such that any flow-induced temperature gradient is cancelled. Information about the airflow can be extracted in the distribution of heating power in the sensor. Ideally, the influence of changes in the ambient temperature on the sensor’s output can be eliminated if in the whole measurement range the temperature sensor sensitivities are equal. However, because of the temperature dependency of the material properties of the airflow and the sensor, it may have a temperature drift. This paper, for the first time, investigates temperature effects of the ceramic microelectromechanical system (MEMS) thermal wind sensor based on the TB mode. The sensor consists of four outlying heaters and four inlying thermistors in two orthogonal directions on a ceramic substrate. When working in the TB mode, it could measure wind speed and wind direction by applying a power difference on the upstream and downstream heaters, so that the flow-induced temperature gradient is eliminated. Theoretical analysis has been developed which takes the variations of thermophysical properties in the sensor and the control circuits into account. Experiments for testing wind speed and direction have been performed in a wind tunnel with an adjustable ambient temperature. It shows that the wind speed is linearly influenced by the ambient temperature while the wind direction is inherently unaffected by ambient temperature variations. After compensation, the sensor shows a credible performance with an error of less than ±1m/s in wind speed and ±2° in wind direction in a temperature range from 0 °C to 30 °C.

Temperature Effect and Its Compensation of a Micromachined 2-D Anemometer

Modeling of Temperature Effects on Micromachined Silicon Thermal Wind Sensors

The Analysis of Temperature Effect and Temperature Compensation of Moems Accelerometer Based on A Grating Interferometric Cavity

Modeling, Simulation, and Fabrication of a 2-D Anemometer Based on a Temperature-Balanced Mode

Temperature Compensation for Thermal Anemometers Using Temperature Sensors Independent of Flow Sensors

Temperature Effects on the Wind Direction Measurement of 2D Solid Thermal Wind Sensors

Micro anemometer by a MEMS compatible lab-on-a-tube technology

Temperature Effects of a Ceramic MEMS Thermal Wind Sensor Based on a Temperature-Balanced Mode

Experiments and Solution of Asymmetry Effect for Mems Thermal Wind Sensor

Temperature Compensation of Micro Thermal Shear Stress Sensor

Modeling and Simulation of Self-Heating Effect with Temperature Difference Air Flow Sensor

Sensitivity Analysis of Micromachined Thermal Wind Sensor Based on Back Surface Sensing Mode

Numerical Modeling of the Performance of Thermoelectric Module with Polydimethylsiloxane Encapsulation

Effect of Packaging Asymmetry on the Performance of A 2d Mems Thermal Wind Sensor with Different Heating Geometries

Efficient system-level simulations of thermal wind sensors considering environmental factors

Novel Temperature Drift Compensation for MEMS Thermal Wind Sensors by Heating Power Calibration Circuits

Design and Optimization of Interface Circuits of MEMS Thermal Wind Speed Sensor Based on a Macro Model

Effects of Ambient Humidity on a Micromachined Silicon Thermal Wind Sensor

Design and Simulation of A Micromachined Cmos Temperature Sensor

Analysis and Experiment of Temperature Effect on the Thermoelectric Power Sensor

Analysis and Compensation of Benchmark Drift of Micromachined Thermal Wind Sensor Caused by Packaging Asymmetry