Abstract:Abstract In this paper, we propose a thermal wind speed sensor Verilog-A model with thermal-fluid-electric hybrid characteristics. Because the structure of the thermal wind sensor and the interface circuit chip are designed separately, which cannot effectively carry out MEMS-IC (integrated circuit) co-simulation, the overall performance of the sensor and interface circuit chip is prone to large deviation. At the same time, the separation of MEMS structure and IC design process leads to long product development cycle and high cost. This paper proposes an improved simulation model by analyzing the behavior characteristics of the thermal wind speed sensor. The simulation model consists of 11 thermistors, 3 capacitors, a voltage-controlled voltage source, and a voltage-controlled current source. The Taylor series expansion of the differential equation of heat conduction is carried out, and then the thermistor and capacitor networks are established according to the corresponding relationship between the thermal parameters and the electrical parameters, including the thermal conduction unit, the convection unit and the heat capacity in the chip. The model fully considers the effects of various physical effects and parasitic effects, and is implemented using the hardware description language Verilog-A. The sensor and interface circuit can be simulated simultaneously to optimize the circuit design. It is beneficial to the integration of sensors and interface circuit, reducing the number of tape-outs, increasing the success rate, and reducing costs. The consistency between the simulation results and the experimental curves verified the correctness of the macro model. The behavior characteristics of constant power (CP) and constant temperature heating were described. In CP mode, the output voltage error is less than ± 6.5%, the chip temperature error is less than 4.0%. The presented modeling approach can be the basis for the development of complete MEMS-IC design technology library of thermal wind speed sensor, aiming at optimum designs of integrated thermal wind speed sensor.

Modeling of Temperature Effects on Micromachined Silicon Thermal Wind Sensors

The Analysis of Temperature Effect and Temperature Compensation of Moems Accelerometer Based on A Grating Interferometric Cavity

Self-adaptive Passive Temperature Management for Silicon Chips Based on Near-Field Thermal Radiation

An efficient macro model for CMOS-MEMS thermal wind speed sensor

Thermal Modeling of Low Power Micromachined Solid State Integrated Gas Sensor

Thermal Drift Analysis Using a Multiphysics Model of Bulk Silicon MEMS Capacitive Accelerometer

Temperature relevant performance and calibration of spin-valve sensor

Thermal Drift Prognosis and Compensation Model of MEMS Accelerometer

Research on Dust Effect for MEMS Thermal Wind Sensors

Thermal-Film Temperature-Difference-Based CMOS Wind Sensor Design and Realization

An Improved Physical Model Considering Mirco-Nano Scale Effects for Numerical Simulation of Pirani Vacuum Gauges

Research On Thermal Conductivity Measurement Of Submicrometer-Scale Silicon Dioxide Film In Thermal Flow Sensor By Micro-Raman Technique

Analytical Study and Compensation for Temperature Drifts of a Bulk Silicon MEMS Capacitive Accelerometer

Experiments and simulations of MEMS thermal sensors for wall shear-stress measurements in aerodynamic control applications

Thermal Modeling of Power Semiconductor Devices with Heat Sink Considering Ambient Temperature Dynamics

A Temperature-Insensitive Micromachined Resonant Accelerometer with Thermal Stress Isolation

Geometric Nonlinear Model for Prediction of Frequency-Temperature Behavior of SAW Devices for Nanosensor Applications

Development of Temperature Sensor Based on AlN/ScAlN SAW Resonators

Thermal Modeling and Compensation of MEMS Accelerometer

Temperature Drift Error Compensation for MEMS Gyroscopes Based on SVR

A Thermal Drift Compensation Method for Precision Sensors Considering Historical Temperature State