Abstract:This paper presents characterization and compensation of the thermal bias drift of a MEMS accelerometer whose effective stiffness is electrostatically tuned to a low value with the help of the single-sided parallel plates (SSPPs) capacitors. A temperature drift model for the proposed accelerometer is built and the temperature effect on the mechanical stiffness and the circuit gains is characterized. The characterization reveals that the variations of the feedforward coefficient including the mechanical stiffness and the readout gain due to the temperature change play a significant role in the bias drift of output of the proposed closed-loop accelerometer. On the other hand, the variations of both feedback gain and tuning gain as a function of temperature are one-order-of-magnitude less than that of the feedforward coefficient. To calibrate the feedforward coefficient, an excitation signal as a form of AC reference displacement is introduced to drive the proof mass and the readout response is demodulated to calibrate the variance of the feedforward coefficient correspondingly. An open-loop compensation scheme for the temperature-induced bias drift using the variance of the calibrated response is proposed accordingly. Alternatively, the calibrated response can be controlled to a preset value by a new proportion integral derivative (PID) controller by the adjustment of the SSPP tuning voltage. The output of the PID controller is used for the calibration of the introduced bias from the electrostatic tuning force. Therefore, a closed-loop compensation of the thermal bias drift is achieved by remaining the feedforward coefficient while eliminating the calibrated bias. Experiments under a temperature cooling process and different tuning voltages are carried out to verify two proposed compensation schemes. The temperature drift coefficients (TDCs) of both compensated outputs exhibit at least one-order-of-magnitude reduction in response to the temperature change. When the effective stiffness of the accelerometer is tuned to about 4.19 N m(-1), the TDC of the compensated output using the proposed open-loop or closed-loop compensation schemes is reduced to about 0.1136 or 0.0391 mg degrees C-1, respectively and meanwhile, the Allan bias instability is slightly increased to 48.63 or 56.14 mu g, respectively.

Temperature relevant performance and calibration of spin-valve sensor

Characterization and Compensation of Thermal Bias Drift of a Stiffness-Tunable MEMS Accelerometer

The Analysis of Temperature Effect and Temperature Compensation of Moems Accelerometer Based on A Grating Interferometric Cavity

Design and Modeling of Vanadium Dioxide-Based High-Sensitivity Microfluidic Calorimetric Sensors

A Temperature Characteristic Research and Compensation Design for Micro-Machined Gyroscope

An Investigation of the Temperature Distributions Inside A Spool Valve Owing to A Viscous Heating Effect

Investigation on the Performance of Spin Valve Magnetic Sensor with Thermal Stability

A Novel Vanadium Dioxide-Based Dual-Heater Microfluidic Thermal Flow Sensor with Record High Sensitivity

Temperature Drift Error Compensation for MEMS Gyroscopes Based on SVR

A Temperature Compensation Method For Micromachined Thermal Gas Gyroscope

Research on Thermal Characteristic and Compensation Algorithm for MEMS-gyroscope

Research on temperature dependent characteristics and compensation methods for digital gyroscope

Research on Low Temperature Drift Suppression of Micro-Machined Gyroscope Based on Self-Calibration Technology

The Affect of Bias Voltage to the DC Test of GMR Spin Valve Biosensors

Temperature Compensation of MEMS Resonant Accelerometers with an On-Chip Platinum Film Thermometer

Temperature prediction and winding temperature measurement of a solenoid valve

The Temperature Effect on the Measuring Accuracy of a Magnetostrictive Liquid Lever Sensor

Temperature Compensation Method for Tunnel Magnetoresistance Micro-Magnetic Sensors Through Reference Magnetic Field

Fabrication of GMR Linear Sensor Based on Spin Valve

Integrating Multiple Hierarchical Parameters to Achieve the Self-Compensation of Scale Factor in a Micro-Electromechanical System Gyroscope

Temperature Compensation In Fluid Density Measurement Using Micro-Electromechanical Resonant Sensor