Abstract:This paper presents characterization and compensation of the thermal bias drift of a MEMS accelerometer whose effective stiffness is electrostatically tuned to a low value with the help of the single-sided parallel plates (SSPPs) capacitors. A temperature drift model for the proposed accelerometer is built and the temperature effect on the mechanical stiffness and the circuit gains is characterized. The characterization reveals that the variations of the feedforward coefficient including the mechanical stiffness and the readout gain due to the temperature change play a significant role in the bias drift of output of the proposed closed-loop accelerometer. On the other hand, the variations of both feedback gain and tuning gain as a function of temperature are one-order-of-magnitude less than that of the feedforward coefficient. To calibrate the feedforward coefficient, an excitation signal as a form of AC reference displacement is introduced to drive the proof mass and the readout response is demodulated to calibrate the variance of the feedforward coefficient correspondingly. An open-loop compensation scheme for the temperature-induced bias drift using the variance of the calibrated response is proposed accordingly. Alternatively, the calibrated response can be controlled to a preset value by a new proportion integral derivative (PID) controller by the adjustment of the SSPP tuning voltage. The output of the PID controller is used for the calibration of the introduced bias from the electrostatic tuning force. Therefore, a closed-loop compensation of the thermal bias drift is achieved by remaining the feedforward coefficient while eliminating the calibrated bias. Experiments under a temperature cooling process and different tuning voltages are carried out to verify two proposed compensation schemes. The temperature drift coefficients (TDCs) of both compensated outputs exhibit at least one-order-of-magnitude reduction in response to the temperature change. When the effective stiffness of the accelerometer is tuned to about 4.19 N m(-1), the TDC of the compensated output using the proposed open-loop or closed-loop compensation schemes is reduced to about 0.1136 or 0.0391 mg degrees C-1, respectively and meanwhile, the Allan bias instability is slightly increased to 48.63 or 56.14 mu g, respectively.

General Problems of Metrology and Measurement Technique Static Component of Temperature Error in the Strain-Gauge Balance: Determination of the Temperature Sensitivity Coefficient

Measurement of Thermal Expansion at Low Temperatures Using the Strain Gage Method

Study on temperature characteristics and correction of strain gauge balance in actual airflow environment

Analysis of Multi-Factor on Measurement Improvement of an Infrared Imager in Low-Temperature Environments

Study on Correlation Between Parameters of "single Factor" Constitutive Model and Temperature for 7050 Aviation Aluminum-Alloy

Characterization and Compensation of Thermal Bias Drift of a Stiffness-Tunable MEMS Accelerometer

A TEMPERATURE-GRADIENT CORRECTION METHOD FOR FILM COOLING EFFECTIVENESS MEASUREMENT USING ENDOSCOPE-BASED PSP TECHNIQUE

ANALYSIS OF MEASUREMENT ACCURACY DURING VERIFICATION OF MIT TEMPERATURE METERS

Temperature correction in acoustoelastic coefficient measurements

Temperature relevant performance and calibration of spin-valve sensor

Sensitivity and Uncertainty Analysis of Nonideal Calibration Standards for 16-Term Error Model

Research On Measurement Of Fiber Bragg Grating Considering The Cross-Sensitivity Of Temperature And Strain

Structural Uncertainty Analysis of High-Temperature Strain Gauge Based on Monte Carlo Stochastic Finite Element Method

Evaluating metrological performance of a pressure balance utilizing a high-precision force transducer: an experimental study

Thermal error compensation in length inspection of large-scale aircraft spars in nonuniform temperature environments

Effect of heat losses in the temperature transducer in measurements in hotshot wind tunnels

Measurement and Control of Ambient Temperature for Metrological Atomic Force Microscope

Simulating Error Due to Acquired Thermoelectric Inhomogeneity

Identification of a Workpiece Temperature Compensation Model for Automatic Correction of the Cutting Process

Measurement technology in hypersonic wind tunnel

Temperature Measuring Method Accuracy Evaluation in the Microarc Heating Process Based on Reproducibility and Uncertainty Indicators