Abstract:Abstract In this paper, we propose a thermal wind speed sensor Verilog-A model with thermal-fluid-electric hybrid characteristics. Because the structure of the thermal wind sensor and the interface circuit chip are designed separately, which cannot effectively carry out MEMS-IC (integrated circuit) co-simulation, the overall performance of the sensor and interface circuit chip is prone to large deviation. At the same time, the separation of MEMS structure and IC design process leads to long product development cycle and high cost. This paper proposes an improved simulation model by analyzing the behavior characteristics of the thermal wind speed sensor. The simulation model consists of 11 thermistors, 3 capacitors, a voltage-controlled voltage source, and a voltage-controlled current source. The Taylor series expansion of the differential equation of heat conduction is carried out, and then the thermistor and capacitor networks are established according to the corresponding relationship between the thermal parameters and the electrical parameters, including the thermal conduction unit, the convection unit and the heat capacity in the chip. The model fully considers the effects of various physical effects and parasitic effects, and is implemented using the hardware description language Verilog-A. The sensor and interface circuit can be simulated simultaneously to optimize the circuit design. It is beneficial to the integration of sensors and interface circuit, reducing the number of tape-outs, increasing the success rate, and reducing costs. The consistency between the simulation results and the experimental curves verified the correctness of the macro model. The behavior characteristics of constant power (CP) and constant temperature heating were described. In CP mode, the output voltage error is less than ± 6.5%, the chip temperature error is less than 4.0%. The presented modeling approach can be the basis for the development of complete MEMS-IC design technology library of thermal wind speed sensor, aiming at optimum designs of integrated thermal wind speed sensor.

Modeling, Simulation, and Fabrication of a 2-D Anemometer Based on a Temperature-Balanced Mode

Wearable Anemometer with Multi-Sensing of Wind Absolute Orientation, Wind Speed, Attitude, and Heading

A novel five-wire micro anemometer with 3D directionality for low speed air flow detection and acoustic particle velocity detecting capability

An angle-of-attack correction method for a 2-D miniature differential pressure solid-state anemometer

A Self-Packaged Two-Dimensional Thermal Wind Sensor Based on Thermopiles for Low Cost Applications

A Compact Fault Tolerant 2-D Anemometer

A Three-Dimensional Ultrasonic Anemometer for Indoor Environmental Applications

Thermal-Film Temperature-Difference-Based CMOS Wind Sensor Design and Realization

High Accuracy and Miniature 2-D Wind Sensor for Boundary Layer Meteorological Observation

ANEMOMETER WITH THREE-DIMENSIONAL DIRECTIONALITY FOR DETECTION OF VERY LOW SPEED AIR FLOW AND ACOUSTIC PARTICLE VELOCITY DETECTING CAPABILITY

Anemometer For Detection Of Very Low Speed Air Flow With Three-Dimensional Directionality

Temperature Compensation for Thermal Anemometers Using Temperature Sensors Independent of Flow Sensors

Measurement Errors and Correction of the UAT-2 Ultrasonic Anemometer

The influence of wind turbine blade rotation on anemometer

Numerical Modeling of the Performance of Thermoelectric Module with Polydimethylsiloxane Encapsulation

Fiber-Optic Hot-Wire Anemometer With Directional Response Based on Symmetry-Breaking Induced Heat Transfer Mechanism

An efficient macro model for CMOS-MEMS thermal wind speed sensor

Design and Test of a Two-dimensional Integrated Flow Sensor by CMOS Technology

Design of a hemispherical shell shaped natural ventilation temperature observation instrument

A New Type of Hot-Wire/film Anemometer

Wind Speed Measurement by an Inexpensive and Lightweight Thermal Anemometer on a Small UAV