Abstract:Wind power generation plays a crucial role in transitioning away from fossil fuel-dependent energy sources, contributing significantly to the mitigation of climate change. Monitoring and evaluating the aerodynamics of large wind turbine rotors is crucial to enable more wind energy deployment. This is necessary to achieve the European climate goal of a reduction in net greenhouse gas emissions by at least 55% by 2030, compared to 1990 levels. This paper presents a comparison between two measurement systems for evaluating the aerodynamic performance of wind turbine rotor blades on a full-scale wind tunnel test. One system uses an array of ten commercial compact ultra-low power micro-electromechanical systems (MEMS) pressure sensors placed on the blade surface, while the other employs high-accuracy lab-based pressure scanners embedded in the airfoil. The tests are conducted at a Reynolds number of 3.5 x 10^6, which represents typical operating conditions for wind turbines. MEMS sensors are of particular interest, as they can enable real-time monitoring which would be impossible with the ground truth system. This work provides an accurate quantification of the impact of the MEMS system on the blade aerodynamics and its measurement accuracy. Our results indicate that MEMS sensors, with a total sensing power below 1.6 mW, can measure key aerodynamic parameters like Angle of Attack (AoA) and flow separation with a precision of 1°. Although there are minor differences in measurements due to sensor encapsulation, the MEMS system does not significantly compromise blade aerodynamics, with a maximum shift in the angle of attack for flow separation of only 1°. These findings indicate that surface and low-power MEMS sensor systems are a promising approach for efficient and sustainable wind turbine monitoring using self-sustaining Internet of Things devices and wireless sensor networks.

A Compact Fault Tolerant 2-D Anemometer

A Multifunctional Electromagnetic Generator for Omnidirectional Wind Energy Harvesting and Self-Powered Wind Vector Detection

Wearable Anemometer with Multi-Sensing of Wind Absolute Orientation, Wind Speed, Attitude, and Heading

A novel five-wire micro anemometer with 3D directionality for low speed air flow detection and acoustic particle velocity detecting capability

Wearable Anemometer for 2D Wind Detection

An angle-of-attack correction method for a 2-D miniature differential pressure solid-state anemometer

Wind Speed and Direction Detection by Means of Solid-state Anemometers Embedded on Small Quadcopters

Airfoil Anemometer With Integrated Flexible Piezo-Capacitive Pressure Sensor

High Accuracy and Miniature 2-D Wind Sensor for Boundary Layer Meteorological Observation

Anemometer For Detection Of Very Low Speed Air Flow With Three-Dimensional Directionality

ANEMOMETER WITH THREE-DIMENSIONAL DIRECTIONALITY FOR DETECTION OF VERY LOW SPEED AIR FLOW AND ACOUSTIC PARTICLE VELOCITY DETECTING CAPABILITY

Design and Test of a Two-dimensional Integrated Flow Sensor by CMOS Technology

A Measurement Technique On The Hydrodynamic Force On The Free Surface-Piercing Cylinder At A Yawed Angle

Two Capacitive Micro-Machined Ultrasonic Transducers for Wind Speed Measurement

A Three-Dimensional Ultrasonic Anemometer for Indoor Environmental Applications

A Compact Flexible Thermal Flow Sensor for Detecting Two-Dimensional Flow Vector

Rugged constant-temperature thermal anemometer

Wind Speed Measurement by an Inexpensive and Lightweight Thermal Anemometer on a Small UAV

Aerodynamic Performance and Impact Analysis of a MEMS-Based Non-Invasive Monitoring System for Wind Turbine Blades

Development of a wireless, non-intrusive, MEMS-based pressure and acoustic measurement system for large-scale operating wind turbine blades

Micro triple-hot-wire anemometer on small sized glass tube fabricated in 5DOF UV lithography system