Abstract:The realization of ohimic contact to n-GaN is usually achieved by using Ti/Al bilayer electrodes with high temperature annealing. Nevertheless, the process of high temperature annealing may destruct the (electronic) structure of devices, such as quantum well and superlattice structure. The ultimate objective of this research work is to obtain low resistance ohimic contact to n-GaN without high temperature annealing, thus (avoiding) the destruction of electronic structure effectively. In the research both nonalloyed condition and low temperature annealing are applied. Under nonalloyed condition, we firstly use alloyed TiAl_3 as contact electrode material directly on n-GaN with carrier concentration of 2×10~(18) cm~(-3). Compared with conventional Ti/Al bilayer structure, alloyed TiAl_3 structure facilitates the realization of nonalloyed n-type ohmic contact. However, with annealing at 500 ℃, the contact behavior of Ti/Al bilayer is improved rapidly and achieves ohmic, which is lower than the temperature assumed in some papers. After applying RIE process, both Ti/Al bilayer and TiAl_3 alloyed electrodes behave ohmic, which indicates that the surface of GaN is cleaning, thus intimate contact of Ti and GaN is vital to (achieve) ohmic contact to n-GaN. In the further experiment, Ti/TiAl_3 bilayer structure is introduced to compare with TiAl_3 alloyed structure. Both of the two structures behave ohmic with RIE process, yet TiAl_3 alloyed shows lower contact resistance, and excess Ti has no obvious effect to contact behavior under nonalloyed condition. After annealing with different temperature, Ti/TiAl_3 bilayer structure tends to form an ohmic contact with lower contact resistance. It proves that excess Ti is activated to form ohmic contact at high temperature annealing. Further analysis implies both of the nitrogen vacancies and TiAl_3 mechanisms play a critical role to form a low contact resistance ohmic contact to n-GaN, under the condition of nonalloyed or low annealing temperature. Accordingly, based on alloyed TiAl_3 structure, Ti/TiAl_3/Ni/Au structure is designed, which decreases the contact resistance significantly, and the specific contact resistance of 3×10~(-5) Ω·cm~2 is obtained with CTLM measurement.The introduction of TiAl_3 alloyed material can make a role as high temperature annealing in the aspect of forming TiAl_3 at the interface. With a certain thickness ratio, Ti/TiAl_3 can achieved low ohmic contact with low temperature annealing. Therefore, TiAl_3 alloyed will be promising in the application field of photoelectron and micro-electron devices that require strict temperature conditions.

Ohmic Contact to AlGaN/GaN HEMT with Electrodes in Contact with Heterostructure Interface

Fabrication and Formation Mechanisms of Ohmic Conducts with Low Annealing Temperature for GaN/AlN Superlattice Barrier HEMTs

Optimization of Contact Resistance and DC Characteristics for AlGaN/GaN HEMTs Utilizing Sub-10 nm Nanohole Etching

Structural investigation of ultra-low resistance deeply recessed sidewall ohmic contacts for AlGaN/GaN HEMTs based on Ti/Al/Ti-metallization

Low-Temperature Ohmic Contact Formation in AlN/GaN HEMT Using Microwave Annealing

Ohmic Contact for InP-Based HEMTs

High thermal stability Ohmic contact for GaN-based devices

Micron-Scale Annealing for Ohmic Contact Formation Applied in GaN HEMT Gate-First Technology

Low Contact Resistance CMOS-Compatible RF GaN-on-Silicon HEMTs

Improved Device Performance in AlGaN/GaN HEMT by Forming Ohmic Contact with Laser Annealing

Si-implantation for Low Ohmic Contact Resistances in RF GaN HEMTs

Process of Au-Free Source/Drain Ohmic Contact to AlGaN/GaN HEMT

Mechanism of Ohmic Contact Formation in AlGaN/GaN High Electron Mobility Transistors Using Microwave Annealing

Improved Ohmic-contact to AlGaN/GaN Using Ohmic Region Recesses by Self-Terminating Thermal Oxidation Assisted Wet Etching Technique

Influence factors and temperature reliability of ohmic contact on AlGaN/GaN HEMTs

Realization of Nonalloyed TiAl3 and Ti/TiAl3 Ohmic Contact to N-Gan

Selective area epitaxy of degenerate n-GaN for HEMT ohmic contact by MOCVD

Effects of Polycrystalline AlN Film on the Dynamic Performance of AlGaN/GaN High Electron Mobility Transistors

InAlGaN-based HEMT with very low Ohmic contact resistance regrown at 850 °C by MOVPE

AlN/GaN HEMTs with Fmax Exceeding 300 GHz by Using Ge-Doped N++gan Ohmic Contacts

Design and Fabrication of Ohmic Contact on AlGaN/GaN Heterostructure