Abstract:In this paper, a new group of active impedance source inverters, along with a suitable control method based on the pulse width modulation (PWM) technique, is presented. Using the proposed control method to produce the gate pulse of the switches, all operating modes of one of the proposed inverters, in two different operations (synchrony and asynchrony), to calculate boost factor and critical inductance in the boundary condition, are analyzed. The comparative analysis from different points of view, such as boost factor, total voltage blocked by diodes and switches, and voltage stresses on capacitors between the proposed topology and conventional structures to examine the advantages and disadvantages, is done. Summary In this paper, a new group of active impedance source inverters, along with a suitable control method based on the pulse width modulation (PWM) technique, is presented. The purpose of these inverters is to reduce the voltage stress on capacitors, diodes, and switches compared to other topologies. Using the proposed control method to produce the gate pulse of the switches, all operating modes of one of the proposed inverters, in two different operations (synchrony and asynchrony), to calculate boost factor and critical inductance in the boundary condition, are analyzed. Furthermore, all equations of voltage and current of components to design the suitable amounts of capacitors and inductors are calculated. Then, the comparative analysis from different points of view, such as boost factor, total voltage blocked by diodes and switches, and voltage stresses on capacitors between the proposed topology and conventional structures to examine the advantages and disadvantages, is done. Also, the losses and efficiency of the proposed topology at different loads are fully given. Finally, a prototype of the proposed topology is designed, and its experimental results are provided to check the performance and correctness of the obtained equations in different operating modes.

An Inverter Chain with Parallel Output Nodes for Eliminating Single-Event Transient Pulse.

A Dual-Output Hardening Design of Inverter Chain for P-hit Single-Event Transient Pulse Elimination

Fault Analysis and Fault-Tolerant Design for Parallel Redundant Inverter Systems in Case of IGBT Short-Circuit Failures

A Capacitively Coupled Digital Isolator Using Multiple-Pulse-coding Architecture with CMTI of 200kv/μs and Static Current of 60Μa.

A Capacitively Coupled Digital Isolator Using Multiple-pulse-coding Architecture with CMTI of 200 Kv/μs and Static Current of 60 Μa

Parallel Control of the Ups Inverters

A fault-tolerant T-type three-level inverter system

Pulse Quenching Effect Characterized by Inverter Chains under Heavy-ion Irradiation in 28-Nm CMOS Technology

Single-Event Multiple Transients in Conventional and Guard-Ring Hardened Inverter Chains under Pulsed Laser and Heavy-Ion Irradiation

Operation Method for Parallel Inverter System with Common Dc Link

A Single Event Upset Tolerant Latch with Parallel Nodes.

A Novel Control Strategy for Input-Parallel-output-series Inverter System

Circulating Currents Suppression for IPOP Non-isolated DC/DC Converters Based on Modified Topologies

A Synchronized Output Regulation Strategy for Seamless Transfer of Single-Phase Utility Interactive Inverters

Elimination of Abnormal Output Voltage in a Hybrid Active NPC Inverter

Characterization of Single-Event Transients Induced by High LET Heavy Ions in 16 Nm Bulk FinFET Inverter Chains

Safe Stop-Pulsing Strategy for IGCT-based Three-Level Neutral Point Clamped Inverters

A new class of active impedance source inverter with low voltage stress on semiconductors

Power Supply Chain with Series Insulation Structure for High Voltage Marx Pulse Generator

Circulating Current Elimination Scheme for Parallel Operation of Common Dc Bus Inverters

Deadbeat Control Strategy for Circulating Current Suppression in Multiparalleled Three-Level Inverters.