Abstract:This paper presents a new fault‐tolerant reduced switch count topology to mitigate reliability issues caused by switch failures in conventional multilevel inverter systems. A reduced number of switches and minimum control complexity make the suggested topology suitable for fault tolerance during single and multiple open‐circuit switch failures. Both symmetric and asymmetric designs are assessed for fault‐tolerant operation in normal, faulty, and post‐fault scenarios. This work exhibits the added reliability and compatibility of the proposed system for industrial applications that need high reliability. Reliability is a major concern in multilevel inverters (MLI) due to the increased number of power switches and diodes, which increases the chance of switch failures and complicates the inverter design. The primary challenges faced by the current MLI design include higher control complexity, increased parasitic elements, more extensive protection, and lack of multiple fault tolerance. Therefore, developing reduced switch MLI with fault‐tolerant ability is crucial to ensure system availability and prevent adverse outcomes. To address these challenges, this article introduces a highly resilient fault‐tolerant reduced switch count (FTRSC) MLI topology offering fault tolerance with minimal switch count. The proposed topology provides fault tolerance in case of single‐ and multiple‐switch open‐circuit (OC) failures. The inherent fault‐tolerant operation is analyzed for the proposed topology's symmetric and asymmetric configurations. The simulation and experimental results validate the effectiveness of the proposed topology considering normal, faulty, and postfault conditions. Furthermore, the reliability evaluation of the proposed work is carried out using the Markov chain model, resulting in a high total mean time to failure of approximately 117,550 h/failures, along with an efficiency of 96.3%. These findings demonstrate that the proposed circuit has enhanced reliability and extended mean time to failure, affirming its suitability for sensitive industrial applications. Finally, a thorough comparison with recent studies highlights the superiority of the proposed system.

A fault-tolerant T-type three-level inverter system

Fault Analysis and Fault-tolerant Design for Parallel Redundant Inverter Systems

Fault Analysis and Fault-Tolerant Design for Parallel Redundant Inverter Systems in Case of IGBT Short-Circuit Failures

A Short-Circuit Fault-Tolerant Strategy for Three-Phase Four-Wire Flying Capacitor Three-Level Inverters

A Redundant Unit to Form T-Type Three-Level Inverters Tolerant of IGBT Open-Circuit Faults in Multiple Legs

Recovering Partial Three-Level Operation in a T-Type Inverter with Fault Management Redundant Unit

Survey on Fault-Tolerant Techniques for Power Electronic Converters

Fault Analysis on Conventional Parallel Inverter Systems

A Single-Phase Multilevel Inverter Topology with Fault Tolerant Capability for Single and Multiple Switch Failures

A Multilevel Converter Topology with Fault-Tolerant Ability

Enhancing Reliability in Multilevel Inverter: A Fault‐Tolerant Approach With Reduced Switch Count

A Unified Fault Tolerant Control and Neutral-Point Voltage Balance Strategy for Three-Level T-Type Inverters under Double Signal PWM

Research on Fault Tolerant Control Method of Three-Level TNPC Inverter

Fast Diagnosis of Multiple Open-Circuit Faults in a T-type Inverter Based on Voltages Across Half-Bridge Switches

Fault-Tolerant Analysis of 5-level Modified T-type and Packed U Cell MLI

A Critical Fault-Tolerant Inverter Based on Internal Evolutionary Short-Circuit Failure Mechanism of IGBT Module

Fault-Tolerant Multiparallel Three-Phase Two-Level Converters With Adaptive Hardware Reconfiguration

Reliability Evaluation of Three-Level Inverters

Open-Circuit Fault-Tolerant Method for Half-Bridge Switches of Three-Level Quasi-Switched Boost T-Type Inverter to Improve Voltage Gain

Real-time Diagnosis of Multiple Transistor Open-Circuit Faults in a T-type Inverter Based on Finite-State Machine Model

A Novel Fault-Tolerant Control Scheme for Shunt Active Power Filter with High Reliability