Abstract:This paper proposes an injected bias current and multiobjective optimal power prediction fault‐tolerant control strategy to mitigate neutral‐point voltage imbalance and achieve a reliable operation of nonredundant T‐type inverters after open‐circuit faults through topology reconfiguration and predictive current control. Summary This paper presents a multiobjective optimal power prediction fault‐tolerant control (MO2PPC) approach for mitigating DC link neutral‐point voltage imbalance and current ripple problems in three‐level T‐type inverter (3LT2I). Additionally, an auxiliary thyristor is employed to isolate and reconstruct the faulty phase into an 8ST2I for ensuring uninterrupted operation during phase failure. A method called injected bias current‐MO2PPC (IBC‐MO2PPC) fault‐tolerant strategy is proposed for this structure. This approach eliminates the need for DC or AC current sensors to reconstruct the three‐phase current, thereby reducing neutral‐point oscillation caused by phase deficiency and ensuring full power output after failure. Additionally, nonfaulty phase power loss is compared and analyzed to verify the stability of this method following a phase fault. The internal losses and temperature distribution of an IGBT module in a bridge arm before and after a fault are verified through a multiphysics‐circuit model in COMSOL‐Simulink coupling simulation presented last. The model shows reduced conduction losses and overall lower temperature distribution in the IGBT module after fault reconstruction. Experiments and multiphysics simulations have demonstrated that this approach displays exceptional robustness and sustainability throughout the entire fault cycle.

A Unified Fault Tolerant Control and Neutral-Point Voltage Balance Strategy for Three-Level T-Type Inverters under Double Signal PWM

A fault-tolerant T-type three-level inverter system

A Short-Circuit Fault-Tolerant Strategy for Three-Phase Four-Wire Flying Capacitor Three-Level Inverters

Recovering Partial Three-Level Operation in a T-Type Inverter with Fault Management Redundant Unit

Fault-Tolerant Control of Dual Three-Phase PMSM Based on Minimum Copper Loss under Multi-Phase Open and Open-Switch Faults

A Proposed Neutral-Point Voltage Balancing Method for Three-Phase Three-Level T-type Inverter under Non-Unity Power Factor

A Redundant Unit to Form T-Type Three-Level Inverters Tolerant of IGBT Open-Circuit Faults in Multiple Legs

Control Strategy of Neutral-point Potential Balancing in Three-level Inverter

A Fault-Tolerant Control Strategy for Three-Level Grid-Connected NPC Inverters after Single-Arm Failure with Optimized SVPWM

A Neutral-Point Potential Balancing Control Method with Third Harmonic Injected Pulse Width Modulation for Three-Level Converters

Research on Fault Tolerant Control Method of Three-Level TNPC Inverter

A Novel Fault-Tolerant Control Scheme for Shunt Active Power Filter with High Reliability

Fault-tolerant Control Strategy with Reduced Switching Frequency for Inverter-Based Fault in Open-Winding PMSM System

Hybrid Modulation Strategy with Neutral Point Potential Balance of T-Type Three-Level Converter under Switch Open-Circuit Fault

Research on the Mechanism of Neutral-Point Voltage Fluctuation and Capacitor Voltage Balancing Control Strategy of Three-Phase Three-Level T-type Inverter

A unified SVPWM fault tolerant control algorithm for single leg fault reconstruction topology of two-level inverter

A Fo-Adrc Based Neutral-Point Potential Balancing For Three-Level Inverter

Common Mode Voltage Reduction and Neutral-Point Voltage Balance for Quasi-Z-Source Three-Level Neutral-Point-Clamped Inverters

Fault-Tolerant Control of ANPC Three-Level Inverter Based on Order-Reduction Optimal Control Strategy under Multi-Device Open-Circuit Fault

A novel fault-tolerant Shunt Active Power Filter and its control strategy

A model predictive fault‐tolerant control strategy for non‐redundant T‐inverters with multiphysics‐circuit coupling loss analysis