Abstract:Zero-sequence circulating current (ZSCC) suppression and fault-tolerant control (FTC) are important guarantees for the safe and reliable operation of parallel T-type three-level rectifiers . However, none of the existing literature can solve the FTC under the ZSCC suppression of the when the open switch fault (OSF) occurs in neutral-point (NP) switches. In order to solve these issues, a novel FTC method based on ZSCC suppression is proposed in this article. First, an improved finite-time controller is constructed to suppress the ZSCC by adjusting the difference of zero-sequence duty ratio between two rectifiers, completely. Then, based on the principle of area equivalence, the switching sequence is reconstructed by changing the state switching mode of the fault phase in real-time. As a result, the FTC under the OSF of NP switches is realized without affecting the suppression of ZSCC. Compared with the existing methods, the proposed method not only realizes the suppression of the ZSCC of the but also completes the FTC under the OSF of NP switches, which guarantees the ZSCC suppression ability under the OSF of NP switches. Consequently, the power quality of the ac side of the is improved significantly during the normal operation and the operation under the OSF of NP switches. Thus, the safe and reliable operation of the is guaranteed effectively. Finally, the feasibility and correctness of the proposed method are verified by e-periment results.

Research on Fault Tolerant Control Method of Three-Level TNPC Inverter

A fault-tolerant T-type three-level inverter system

Fault Analysis and Fault-tolerant Design for Parallel Redundant Inverter Systems

A Short-Circuit Fault-Tolerant Strategy for Three-Phase Four-Wire Flying Capacitor Three-Level Inverters

Fault-Tolerant Control of ANPC Three-Level Inverter Based on Order-Reduction Optimal Control Strategy under Multi-Device Open-Circuit Fault

Fault-Tolerant Control of Dual Three-Phase PMSM Based on Minimum Copper Loss under Multi-Phase Open and Open-Switch Faults

A Unified Fault Tolerant Control and Neutral-Point Voltage Balance Strategy for Three-Level T-Type Inverters under Double Signal PWM

Recovering Partial Three-Level Operation in a T-Type Inverter with Fault Management Redundant Unit

A Fault-Tolerant Control Strategy for Three-Level Grid-Connected NPC Inverters after Single-Arm Failure with Optimized SVPWM

Fault-tolerant Control Strategy with Reduced Switching Frequency for Inverter-Based Fault in Open-Winding PMSM System

Open-Circuit Fault Diagnosis and Fault-Tolerant Control for a Grid-Connected NPC Inverter

A Redundant Unit to Form T-Type Three-Level Inverters Tolerant of IGBT Open-Circuit Faults in Multiple Legs

A Novel Fault-Tolerant Control Scheme for Shunt Active Power Filter with High Reliability

L- and LCL-Filtered Grid-Tied Single-Phase Inverter Transistor Open-Circuit Fault Diagnosis Based on Post-Fault Reconfiguration Algorithms

An Igbt Open-Circuit Fault Diagnosis Method For Grid-Tied T-Type Three-Level Inverters

Diagnosis and Tolerance of Common Electrical Faults in T-Type Three-Level Inverters Fed Dual Three-Phase PMSM Drives

A Novel Method For Improving The Fault Tolerance Of Transformerless Cascade Pwm Statcom

The Tolerance Control Method Based on Zero-Sequence Circulating Current Suppression for Parallel T-type Three-Level Rectifiers

Control Strategy of Neutral-point Potential Balancing in Three-level Inverter

Control method for cascaded H-bridge multilevel inverter with faulty power cells

Reliability analysis and reliable operation of three-level ANPC inverter