Abstract:The series resonance type fault current limiter has the advantages of simple operating principle and topological structure,etc. The primary parameter of series resonance type fault current limiter for high-voltage system is reasonable.However,in the process of restraining fault current after a fault occurrence in electrical network,the capacitor and parallel inverter switch will confront poor working condition.This paper studies the above condition by simulation using the software Matlab.Proceeding from the study,we arrive at the conclusions:1)in the process of closing the inverter switch short circuit capacitor to make the current limiter work in short circuit current limiting mode switching from normal operation mode,there is higher-order of voltage(current)oscillation between capacitor and parallel inverter switch,and the peak value of voltage(current)increases and oscillates with the growing of the speed for closing the inverter switch; 2)when the inverter switch is composed of semiconductor device,control system must respond to short circuit and close the inverter switch quickly,otherwise,the semiconductor device may be damaged by over current(voltage);3)during fault current limiter working in current limiting mode to short circuit loop being shut off by relay protection device,the inverter switch will bear the full fault current and oscillation current.If using semiconductor device as inverter switch,the capacity of semiconductor device must be chosen according to the working condition.

Fault Analysis on Conventional Parallel Inverter Systems

Fault Analysis and Fault-Tolerant Design for Parallel Redundant Inverter Systems in Case of IGBT Short-Circuit Failures

Fault Analysis and Fault-tolerant Design for Parallel Redundant Inverter Systems

Survey on Fault-Tolerant Techniques for Power Electronic Converters

A Comparative Study of Two Diagnostic Methods Based on the Switching Voltage Pattern for Igbt Open-Circuit Faults in Voltage-Source Inverters

A fault-tolerant T-type three-level inverter system

Modeling and Analysis of Switching Frequency Circulating Currents in Parallel Inverter Systems

Analysis on non characteristic harmonic circulating current in parallel inverter system and its suppression measures

Modeling, Analysis, and Implementation of Parallel Multi-Inverter Systems with Instantaneous Average-Current-Sharing Scheme

Study on the Over-Voltage and Over-Current of Grid-Connected Inverters in Non-Fault Conditions

Fast Diagnosis of Multiple Open-Circuit Faults in a T-type Inverter Based on Voltages Across Half-Bridge Switches

A Literature Review of IGBT Fault Diagnostic and Protection Methods for Power Inverters

Simulation Study of Series Resonance Type Fault Current Limiter

An Average Model-Based Transistor Open-Circuit Fault Diagnosis Method for Grid- Tied Single-Phase Inverter

Topology, Control and Fault Analysis of a New Type HVDC Breaker for HVDC Systems

Linearization Equivalent Model Study of IIDG Fault Output with Low Current Limiting

L- and LCL-Filtered Grid-Tied Single-Phase Inverter Transistor Open-Circuit Fault Diagnosis Based on Post-Fault Reconfiguration Algorithms

A Critical Fault-Tolerant Inverter Based on Internal Evolutionary Short-Circuit Failure Mechanism of IGBT Module

Cascaded SAPF Fault Diagnosis Method Based on H-bridge Voltage and Current

Fault Analysis and Simulation of the Short Circuit in High-Power Fusion Magnet Power Supply

Fault Modeling of IIDG Considering Inverter’s Detailed Characteristics