Abstract:This article proposes a fault-tolerant control method for an input-parallel–output-series (IPOS) converter under open-circuit switch failure, which mainly focuses on two parts: fault diagnosis (fault detection and fault identification) and remedial action. The fault diagnosis is realized based on immersion and invariant observer (I&IO), which has strong robustness to parameter uncertainty and external disturbances, and therefore, it can be designed using only the crude converter model with nominal parameters. Moreover, the sampling frequency required by the fault diagnosis is the same as the frequency required by the system controller. Thus, the fault diagnosis module can be easily embedded in the well-designed power system without extra sensors. Based on the method, the open-circuit fault in power switches can be detected and identified within two switching periods. As for remedial action, two redundant switches are needed for postfault reconfiguration. Also, the remedial action can be immediately triggered after the switch failure is detected. To reduce the complexity of remedial action, the same postfault reconfiguration will be carried out for the open-circuit failure in different switches. Besides, system controllers are also carefully designed to guarantee the performance of the postfault converter. Both simulations and experiments are conducted for the validations, and the results have shown the effectiveness, robustness, and rapidity of the proposed method.

Fault Analysis and Fault-Tolerant Design for Parallel Redundant Inverter Systems in Case of IGBT Short-Circuit Failures

Fault Analysis and Fault-tolerant Design for Parallel Redundant Inverter Systems

Fault Analysis on Conventional Parallel Inverter Systems

Survey on Fault-Tolerant Techniques for Power Electronic Converters

A fault-tolerant T-type three-level inverter system

A Comparative Study of Two Diagnostic Methods Based on the Switching Voltage Pattern for Igbt Open-Circuit Faults in Voltage-Source Inverters

A Critical Fault-Tolerant Inverter Based on Internal Evolutionary Short-Circuit Failure Mechanism of IGBT Module

Fault-Tolerant Inverter Operation Based on Si/SiC Hybrid Switches

Ensuring a Reliable Operation of Two-Level IGBT-Based Power Converters: A Review of Monitoring and Fault-Tolerant Approaches

A Novel Fault-Tolerant Control Scheme for Shunt Active Power Filter with High Reliability

Analysis on non characteristic harmonic circulating current in parallel inverter system and its suppression measures

Study on the Over-Voltage and Over-Current of Grid-Connected Inverters in Non-Fault Conditions

A Redundant Unit to Form T-Type Three-Level Inverters Tolerant of IGBT Open-Circuit Faults in Multiple Legs

Investigation of A Fault-Tolerant Three-Level T-Type Inverter System

Fault Diagnosis and Fault-tolerant Operation of Current Source Inverter for Safety-Critical Applications

Fault-tolerance Operation Analysis of Multiphase Interleaved Inverters Based on Short-Circuiting Windings

Fault Analysis of An IPRB Microgrid with Multiple Grid Forming Inverter-based Sources

Short-circuit fault protection strategy of parallel three-phase inverters

Parallel Open-Circuit Fault Diagnosis for Cascaded Full-Bridge NPC Inverter with Carrier Phase Shifted Modulation

Transient Stability Analysis of Paralleled Grid-Following Inverter and Virtual Synchronous Generator Considering Transient Mode Switching

Open-Circuit Switch Fault Diagnosis and Fault- Tolerant Control for Output-Series Interleaved Boost DC–DC Converter