Abstract:A grid-forming (GFM) inverter can effectively support active power and reactive power, and the stability problem induced by the low inertia can be thereby alleviated in a power electronics-dominated power system. Yet, the voltage source characteristic presented by the grid-forming inverter induces an overcurrent problem during a short-circuit fault. Furthermore, the time delay induces an inrush current in traditional digital control, triggered by a predefined timing sequence. To address the overcurrent problem of the GFM inverter controlled by the digital controller, the operation characteristics of GFM inverters under grid-voltage drops are investigated, and a mathematical model of the instantaneous fault current is established, which depicts the relationship between the instantaneous fault current's magnitude, grid-voltage drop severity, equivalent output impedance, and current inner-loop response speed. Then, a Set–Reset (SR) latch-based dynamic current limitation with event-triggered control is proposed for the low-voltage ride-through of the GFM inverter. In the proposed method, the current limitation is enabled during grid fault, and the active and reactive powers can be recovered rapidly after fault clearance. Meanwhile, the active and reactive power references are designed to enhance synchronization stability during the grid fault. The proposed method addresses the issue of the repeated switching of virtual impedance during grid fault and achieves rapid power recovery after fault clearance. In addition, the proposed method uses the logic of event triggers to respond to the overcurrent event in real time and realize overcurrent protection. The simulation and experimental results demonstrate the effectiveness of the proposed method in current limitation and active-power recovery after fault clearance.

Linearization Equivalent Model Study of IIDG Fault Output with Low Current Limiting

Optimized Planning of Inverter Interfaced Distributed Generation Considering Relay Constraints

Simulative Analysis and Equivalent Reduction for Micro-Grid

Fast and Accurate Method for Short-Circuit Current Calculation in Distribution Network with Iidgs

Fault Modeling of IIDG Considering Inverter’s Detailed Characteristics

Analysis of Grid-Forming IIDG’s Transient- and Steady-State Fault Model

Modeling and Research of Three-Phase Inverter Powering Nonlinear Load

A Novel Doubly Fed Induction Generator System with Fault Ride Through Capability

Control Strategy of Non-Linear Discrete Time-Optimal Error Feedback in PV Grid-Connected Inverter

Enhancing Short-Circuit Current Calculation in Active Distribution Networks Through Fusing Superposition Theorem and Data-Driven Approach

Improved Control Strategy for Stand-Alone Distributed Generation System under Unbalanced and Non-Linear Loads

Transient Characteristic Modeling of DFIG Considering Control Loop under Grid Voltage Fault

Improved Virtual Synchronous Generator Control of DFIG to Ride-Through Symmetrical Voltage Fault

Collaborative Control of DFIG System During Network Unbalance Using Reduced-Order Generalized Integrators

Equivalent method of grid-connected photovoltaic sources for medium-voltage distribution networks fault analysis

A Novel Fault Ride Through Strategy for Grid-Connected Virtual Synchronous Generators: Power Angle Stability Enhancement and Current Limiting

Rapid Modeling and Simulation Method for Inverter-interfaced Distributed Generators

A Fault Direction Criterion Based on Post-Fault Positive-Sequence Information for Inverter Interfaced Distributed Generators Multi-Point Grid-Connected System

Adaptive low voltage crossing strategy for symmetrical faults of networked inverters

Dynamic Current-Limitation Strategy of Grid-Forming Inverters Based on SR Latches

Research on the Control Method of the PV Grid-Connected Inverter under an Asymmetrical Power Grid Fault