Abstract:High-power pulse generators are widely used in civil and military fields. The main switch directly determines the output characteristics of the high-power pulse generators, such as the voltage front time (tf). Pseudospark switches (PSS) show a promising future for middle voltage, high repetitive frequency pulse power applications. However, how to further improve the breakdown behavior without reducing its advantages is a challenging task. In this paper, the influence of operating parameters (anode voltage UA and gas pressure p) and structural parameter (number of cathode holes) on the breakdown behavior are investigated, the related mechanism are explained, and specific improvement schemes are proposed. It is found that the tf of the single channel PSS (SCPSS) decreased significantly with increasing p, but hardly varied with UA under moderate p. However, it is not a sound solution to increase the p excessively to reduce tf. Besides, increasing the number of cathode holes can obtain a shorter tf at low pressures (which implies superior repetition frequency performance). However, at 25 Pa, the jitter (which is defined as the standard deviation of tf in multiple tests) of the 2-channel PSS is larger than that of the SCPSS. And the jitter of the 4-channel and 8-channel PSS is also greater than 6 ns and 2 ns, respectively. Through experimental and simulation analyses, it can be explained as the stepwise penetration of the virtual anode and the non-simultaneous ignition of the channels. A scheme to increase the trigger energy (ε) has been adopted to improve the simultaneous ignition probability, while shortening tf and reducing jitter. After optimization, the good ignition probability of the 4-channel PSS has been improved to 82% and the jitter has been reduced to less than 1 ns at 25 Pa and 14.7 mJ.

Power Supply Chain with Series Insulation Structure for High Voltage Marx Pulse Generator

Investigation on a Novel Multiple-Switch Pulsed Power Technology

A pulsed power generator with a 20 stage transmission-line-transformer and 20 spark-gap switches

Novel Multiple-switch Pulsed Power Technologies

Development of a Heavy Duty Pulsed Power Generator with Ten Spark Gap Switches

An Efficient, Repetitive Nanosecond Pulsed Power Generator with Ten Synchronized Spark Gap Switches

Inductive Pulsed Power Supply Consisting of Superconducting Pulsed Power Transformers with Marx Generator Methodology

A Repetitive Pulser with Four Spark Gap Switches

All Solid-State Pulsed Power Generator with Semiconductor and Magnetic Compression Switches

A Compact High-Power Ultra-Wideband Bipolar Pulse Generator

An All Solid-State Pulsed Power Generator Based on Marx Generator

All-Solid-State Repetitive Pulsed-Power Generator Using IGBT and Magnetic Compression Switches

Repetitive and High Voltage Marx Generator Using Solid-State Devices

An Inductive Isolation-Based 10 kV Modular Solid Boost-Marx Pulse Generator

Solid-state Marx generator based on saturable pulse transformer and fast recovery diodes

Development of P-C Switch with Adjustable Gap

Influence factors and improvement scheme on the breakdown behavior of pseudospark switch

All Solid-State Nanosecond Pulsed Generators Based on Marx and Magnetic Switches

Solid-State Spiker-Sustainer Circuit Consisting of PFN and SOS

The Development of Solid-state Pulse Generator Based on Marx Circuit with Chopping Switch

Preliminary Experiments on 0.1 TW Pulsed Power Generator