Abstract:Pulsed power technology has traditionally served in the field of defense technology and is generally operated in a single operation. With the increasing demand in the military and high-energy physics fields, especially in the fields of medicine [1], industry, environmental protection and electromagnetic interference, the demand for high average power is becoming more and more urgent, requiring the pulse source to be in a high repetition frequency operating state. The high-repetition-frequency high-voltage pulse source is a pulse power system that can operate at high repetition frequencies and generate high voltage pulses. Ultra-wideband electrical pulse sources with small size and all solid-state structures are easier to integrate into the system and compatible with other devices. This paper introduces the design and implementation of a high-repetition-frequency high-voltage pulse generating device. The device is mainly composed of a pulse signal source module, a power amplification module and a pulse compression module. The article describes in detail about the pulse signal generation module based on MCU (micro-controller unit) and FPGA (field programmable gatearray) with adjustable frequency adjustable pulse width at the source level, the pulse signal power amplification module based on DSRD (drift step recovery diode) [2] switch, the pulse compression module based on the principle of diode reverse recovery. The final test results show that the device can work at 1MHz repeat frequency, the output pulse peak voltage can be up to 1700V on 50 Omega load, the output pulse rising edge is less than 1 ns, and the half pulse width is up to 1.9 ns. If the pulse compression module is connected, the half pulse width can reach 1.56 ns and the compression ratio can reach 87%.

Solid-State Spiker-Sustainer Circuit Consisting of PFN and SOS

A Repetitive Pulser with Four Spark Gap Switches

Investigation on a Novel Multiple-Switch Pulsed Power Technology

An Efficient, Repetitive Nanosecond Pulsed Power Generator with Ten Synchronized Spark Gap Switches

New SOS Diode Pumping Circuit Based on an All-Solid-State Spiral Generator for High-Voltage Nanosecond Applications

A NOVEL NANOSECOND SEMICONDUCTOR OPENING SWITCH FOR MEGAVOLT REPETITIVE PULSED POWER TECHNOLOGY: EXP

Characteristics of pseudospark switches for pulsed power modulators

A Compact Series-Connected SiC MOSFETs Module and Its Application in High Voltage Nanosecond Pulse Generator

Design, Implementation And Analysis Of Solid-State Megahertz Continuous High-Repetition-Frequency High-Voltage Pulse Source

High-Voltage Pulsed Power Based On Series-Connected Full-Bridge And Solid-State Switches

Power Supply Chain with Series Insulation Structure for High Voltage Marx Pulse Generator

A 7.8 kV nanosecond pulse generator with a 500 Hz repetition rate

An All-Solid-State Pulsed Power Generator for Non-Thermal Plasma Discharge Applications 1

All-Solid-State Ultrashort Pulse Generator by Capacitive Chopping Circuit

Solid-state High-voltage Nanosecond Switch Module

SOS-Based Pulsed Power Generator and Its Applications

All Solid-State Pulsed Power Generator with Semiconductor and Magnetic Compression Switches

High Voltage Nanosecond Pulse Generator Based on Pseudospark Switch and Diode Opening Switch.

A Novel Boost Marx Pulse Generator Based on Single-Driver Series-Connected SiC MOSFETs

One type of high voltage bipolar square pulser based on all-solid-state switch devices

Self-Triggering High-Frequency Nanosecond Pulse Generator