Preliminary Experiments on 0.1 TW Pulsed Power Generator

Lu-ya HE,Xiao-bing ZOU,Nai-gong ZENG,Rui LIU,Xiao LIU,Min HAN,Gui-xin ZHANG,Xin-xin WANG

DOI: https://doi.org/10.3969/j.issn.1003-6520.2007.11.050

2007-01-01

Abstract:0.1 TW pulsed power generator (PPG-I) constructed for the research on X-pinch and Z-pinch was tested. The generator is composed of a 1.2 MV Marx generator with sixteen 0.65-μF capacitors charged to 75 kV in parallel and then erected in series, a 1.25 Ω pulse forming line (PFL) using distilled water as insulation, a V/N spark switch filled with pressurized SF6 gas, a 1.25 Ω pulse transmission line (PTL) using also distilled water as insulation and a 1.25-Ohm pseudo-load made of CuSO4 solution. It is found that the output voltage of PPG-I is influenced by the pressure of SF6 filled in the auxiliary gap of the V/N switch when the SF6 pressure of main gap keeps at 4.6 atm. If SF6 pressure in the auxiliary gap is 2.7 atm, the auxiliary gap will first self-break down at the time when the PFL is charged to a voltage of 1.1 MV, near its maximum charging voltage, causing multi-channel discharge in the main gap. In this case, the output voltage with a 1.25 ohm matching load is a square-wave with 470 kV in amplitude, 30 ns in risetime and 110 ns in FWHM. If SF6 pressure in the auxiliary gap rises to 3.4 atm, the auxiliary gap will not break down and the main gap breaks down with only one discharge channel when the PFL is charged to 1.1 MV. In this case, the output voltage of 440 kV in amplitude rises much more slowly with a risetime of 70 ns and without a flat top. It is concluded that the output voltage pulse from PPG-1 is suitable for driving X-pinch and Z-pinch load when the V/N switch works in multi-channel discharge mode.