An Efficient, Repetitive Nanosecond Pulsed Power Generator with Ten Synchronized Spark Gap Switches
Z. Liu,A. J. M. Pemen,R. T. W. J. van Hoppe,G. J. J. Winands,E. J. M. van Heesch,K. Yan
DOI: https://doi.org/10.1109/tdei.2009.5211834
IF: 2.509
2009-01-01
IEEE Transactions on Dielectrics and Electrical Insulation
Abstract:This paper describes an efficient, repetitive nanosecond pulsed power generator using a Transmission-Line-Transformer (TLT) based multiple-switch technology. Within this setup, a 10-stage TLT and ten high-pressure spark-gap switches are adopted. At the input side, ten spark-gap switches are interconnected in series via the TLT, so that all the spark-gap switches can be synchronized automatically. At the output side, all the stages of the TLT are connected in parallel, thus a low output impedance (5 12) is obtained, and a large output current is realized by adding the currents through all the switches. Experimental results show that 10 spark-gap switches can be synchronized within about 10 ns. The system has been successfully demonstrated at repetition rates up to 300 pps (Pulses Per Second). Pulses with a rise-time of about 11 ns, a pulse width of about 55 ns, an energy of 9-24 J per pulse, a peak power of 300-810 MW, a peak voltage of 40-77 kV, and a peak current of 6-11 kA have been achieved with an energy conversion efficiency of 93-98%.