Abstract:To increase the power rating and improve the reliability of the single-phase power supply system, the input-parallel output-parallel (IPOP) single-phase dc/ac converters (SDACs) are widely used. However, among the IPOP SDACs, there are complicated circulating currents which will increase the current stress on the switching devices and influence the safe operation of the system. But, the detailed quantitative analysis of the circulating currents is not well developed and the corresponding suppression strategies are not very comprehensive. Focusing on these problems, this paper pays attention to the detailed mathematic model and effective suppression strategy of circulating currents among IPOP SDACs. First, the detailed mathematic model of the circulating currents is established. Based on this model, it is found that there are various types of circulating currents existing in the IPOP SDACs, including circulating currents within the single SDAC and circulating currents among the multiple SDACs. At the same time, the influence factors are also analyzed, and it is first revealed that the asymmetry of impedances in different sides will cause circulating currents with different frequencies components including the dc, fundamental, and second frequencies. Second, after the detailed analysis, a decentralized control method composed of the common mode (CM) and differential mode (DM) control is proposed to suppress the complicated circulating currents. The control method is comprehensive and can suppress circulating currents caused by diverse influence factors. All the theoretical analyses are verified by the real-time hardware-in-loop (HIL) tests.

Circulating Currents Suppression for IPOP Non-isolated DC/DC Converters Based on Modified Topologies

Modeling and Analysis of Circulating Currents among Input-Parallel Output-Parallel Nonisolated Converters

Decentralized Suppression Strategy of Circulating Currents among IPOP Single-Phase DC/AC Converters

Circulating Currents Suppression Based on Two Degrees of Freedom Control in DC Distribution Networks

Circulating Current Generation Mechanism and Control Strategy for IPOP Buck Converters

Synthesis of Multi-Port Converters Based on Series/parallel Input Pulsating Cells and Output Pulsating Cells

A novel input-parallel output-parallel connected DC-DC converter modules with automatic sharing of currents

Modeling and Analysis of Switching Frequency Circulating Currents in Parallel Inverter Systems

Automatic Current Sharing of an Input-Parallel Output-Parallel (Ipop)-Connected DC–DC Converter System with Chain-Connected Rectifiers

Common-Duty-Ratio Control of Input-Parallel Output-Parallel (IPOP) Connected DC–DC Converter Modules with Automatic Sharing of Currents

Design and Analysis of Multiloop Controllers with DC Suppression Loop for Paralleled UPS Inverter System

A Coupled-Inductor-Based Input-Parallel Output-Parallel Quasi-Resonant Single-Stage DC–DC Converter to Mitigate Current Difference

Circulating Currents Suppression Based On Common Mode And Differential Mode Control In Dc Distribution Systems

Analysis and Suppression of Common-Mode EMI Noise in 1 MHz 380 V-12 V DCX Converter with Low NFoM Devices

A Novel Circulating Current Suppression for Paralleled Current Source Converter Based on Virtual Impedance Concept

Automatic Current Sharing Of Input-Parallel Output Parallel Dual Active Bridge Converters With Coupled Inductors

Circulating Current Suppression of the Arm-Multiplexing High-Voltage DC Transformer

Design of an Input-Parallel Output-Parallel Multi-Module DC-DC Converter Using a Ring Communication Structure

Suppression of Circulating Current Caused by Multiple DG Negative Pole Ground Fault in DC Microgrid Based on Control With Two Degrees of Freedom

The Research on Carrier Phase-shift SPWM and Circulating Currents in Parallel Converters

Topology Derivation of Nonisolated Three-Port DC–DC Converters from DIC and DOC