Abstract:Severe plastic deformation (SPD) techniques have attracted significant attention in the last two decades due to its capacity of producing bulk ultra-fine grained (UFG) or nanostructured materials, by imposing very high plastic strain. Equal channel angular pressing (ECAP), or equal channel angular extrusion (ECAE), is one of the most widely used SPD techniques. During ECAP, a sample is pressed through a die which consists of two channels with equal cross-section intersecting at an angle varying from 60 degrees to 150 degrees. Since the cross-section geometry of the sample remains nearly unchanged, the materials can be deformed to a very high strain by repeating the process. The deformation mechanism of ECAP is very complicated and it is dependent on the die geometry and material properties. It has been assumed as simple shear on the intersecting plane of two channels at ideal conditions, such as frictionless, perfectly plastic material and very sharp outer corner. However, from the view of texture evolutions, many experimental results have revealed the deviation from the ideal simple shear. Therefore, an insight into the deformation mechanism and orientation changes in the real ECAP case is still essential. In the present work, a comprehensive study based on the crystal plasticity finite element model (CPFEM) has been conducted to investigate the stress state, plastic strain, required load and crystallographic orientation development history of aluminum single crystals subjected to ECAP. The influence factors such as ECAP die geometry, frictional conditions and initial crystallographic orientations have been studied in detail.

Deformational Features and Microstructure Evolution of Copper Fabricated by a Single Pass of the Elliptical Cross-Section Spiral Equal-Channel Extrusion (ECSEE) Process

Microstructure Evolution and Microhardness Distribution of Copper Processed Using Multiple Passes of Elliptical Cross-Sectional Spiral Equal-Channel Extrusion

Numerical and Experimental Studies of Pure Copper Processed by a New Severe Plastic Deformation Method

A Novel Severe Plastic Deformation Method for Fabricating Ultrafine Grained Pure Copper

Analysis of Deformation Textures and Microstructure in ECAE Processed Copper Single Crystals Via Route C

Microstructural Evolution and Micro/Meso-Deformation Behavior in Pure Copper Processed by Equal-Channel Angular Pressing

Experimental Study on Pure Copper Subjected to Different Severe Plastic Deformation Modes

Microhardness Distribution and Microstructural Evolution in Pure Aluminum Subjected to Severe Plastic Deformation: Elliptical Cross-Sectioned Spiral Equal-Channel Extrusion (ECSEE)

Microstructure and Mechanical Properties of Pure Copper Subjected to Skin Pass Asymmetric Rolling

EBSD Analysis of Deformed and Partially Recrystallized Microstructures in ECAE-Processed Copper

Deformation Analysis of Elliptical Cross-Section Spiral Equal-Channel Extrusion Technique

Experimental and numerical study on the micro-forming of copper multi-crystal

Producing Thin-Walled Tube of Pure Copper by Severe Plastic Deformation of Shear Extrusion

An Insight into the Deformation and Orientation Development of Severely Plastic Deformed Aluminum

Modeling Texture Evolution During ECAP of Copper Single Crystal by Crystal Plasticity FEM

1216 Nano-Scale Strength Analysis by EBSD and AFM Hybrid Method in Ultrafine-Grained Copper Processed by ECAP

Strain localization and ductile fracture mechanism of micro/mesoscale deformation in ultrafine-grained pure copper

Fatigue Behavior and Damage Characteristic of Ultra-Fine Grain Low-Purity Copper Processed by Equal-Channel Angular Pressing (ECAP)

Effect of Crystalline Anisotropy and Forming Conditions on Thinning and Rupturing in Deep Drawing of Copper Single Crystal

Effect of grain refinement on mechanical and electrochemical properties of severely deformed pure copper through equal channel angular pressing

Influence of Cold Rolling Routes on Mechanical Properties of Copper Subjected to ECAP