Abstract:Equal channel angular pressing (ECAP) is a novel method for producing very high plastic strain, and, subsequently, ultrafine grains in materials, with no change in the billet s shape. However it is very important. to understand the deformation behavior of the materials and their relationships with the friction condition and tooling configuration during the ECAP process before it can be exploited in the engineering field. In this study, the plastic deformation behavior of pure Al during the ECAP process with a die corner angle (120...) was investigated using the commercial two-dimensional rigid-plastic finite element software (DEFORM2D). It has been found that the ECAP process was characterized by five steps based on the analysis of the calculated load-ram displacement curve (fast increasing, slowly increasing, another fast increasing, steady state and finally decreasing stages). The inhomogeneous strain distribution within the billets was analyzed by separating the billets into a front transient zone, an end transient zone, an outer less sheared zone, and the remaining shearing deformation zone, which is also proved by the experiment using the billets with scribed grids. Elimination of friction will improve the deformation inhomogeneity of the billet, but cannot eliminate the deformation inhomogeneity. The homogeneity of the strain distribution in the center of the billet is strongly dependent upon the shape of the deformation zone, i.e. angle phi, which will influence the material flow rate distribution and the stress state. Using a corner die instead of a round die, the material flow rate in the main deformation zone is nearly homogenous because of the inexistence of the tensile stress component in the outer part of the billet; consequently the homogeneity of deformation is greatly enhanced.

An Insight into the Deformation and Orientation Development of Severely Plastic Deformed Aluminum

Influence of Outer Corner Angle (OCA) on the Plastic Deformation and Texture Evolution in Equal Channel Angular Pressing

Crystal Plasticity Modeling of Texture Evolution and Heterogeneity in Equal Channel Angular Pressing of Aluminum Single Crystal

Experimental and Numerical Investigation on Pure Aluminum by ECAP

Severe plastic deformation of commercially pure aluminum using novel equal channel angular expansion extrusion with spherical cavity

A Study on the Aluminum Alloy AA1050 Severely Deformed by Non-Equal Channel Angular Pressing

Crystal Plasticity FEM Study on the Influence of Crystallographic Orientation in Copper Single Crystals Subjected to Equal Channel Angular Pressing

FEM Simulation of Micro-Crystalline Materials During ECAP Based on the Dislocation Evolution Method

Analysis of plastic deformation behavior during equal channel angular pressing

Deformation Behavior Analysis and Process Investigation of Equal Channel Angular Pressing

Severe plastic deformation techniques for bulk ultra-fine-grained materials

Microhardness Distribution and Microstructural Evolution in Pure Aluminum Subjected to Severe Plastic Deformation: Elliptical Cross-Sectioned Spiral Equal-Channel Extrusion (ECSEE)

Crystal Plasticity Investigation of Texture Evolution of Al Single Crystal During Extrusion Through a Bent Channel

Grain Refinement and Strengthening of an Aluminum Alloy Subjected to Severe Plastic Deformation through Equal-Channel Angular Pressing

Investigation on Plastic Flow Behaviors of FCC Polycrystalline Aluminum under Pre-Cyclic Tension-Compression Loading: Experiments and Crystal Plasticity Modeling.

Achieving Grain Refinement and Related Mechanical Property Improvement of an Al-Zn-Mg-Cu Alloy Through Severe Plastic Deformation

Experimental Study on Pure Copper Subjected to Different Severe Plastic Deformation Modes

Present State and Perspectives of Severe Plastic Deformation

Investigating the Influence of Thermomechanical Equal Channel Angular Pressing (ECAP) Improved Die on AA-6061

Numerical Analysis of Nano- or Micro-Crystalline Materials During Ecap by Dislocation Evolution Method

Mechanical responses, texture and microstructural evolution of high purity aluminum deformed by equal channel angular pressing