Abstract:This study explores the phenomenon of slip transmission across grain boundaries in coarse-grained copper. The associated effects on the deformation gradient are also investigated, using both experiment and simulation. An in-situ tensile test of a fully annealed copper specimen was conducted first using a scanning electron microscope (SEM). The deformation gradient and geometrically necessary dislocation (GND) maps at selected tensile strain values were obtained and characterized by electron backscatter diffraction (EBSD). In addition, a physically based strain gradient crystal plasticity finite element method model has been developed to simulate the early stage of tensile deformation behaviour of copper. In this model, slip transmission across the grain boundary is either allowed or blocked, depending on the alignment of adjacent grains. Slip transmission is allowed at grain boundaries between suitably aligned grains according to the Luster-Morris factor, residual Burgers vector is applied to consider the slip misalignment at GB region, and dislocation accumulation at grain boundaries is included following the Kocks-Mecking law. It was found that dislocation pile-up, lattice rotation and stress concentration were much higher near the impenetrable grain boundaries than at the penetrable ones. Due to the slip transmissions across grain boundaries, the stress and strain concentrations can be partially relaxed, and the slip transmission induced relaxation is associated with the number of active slip systems and shear strain on the best aligned slip systems. This study provides an effective strategy to investigate the early stage of plastic deformation, and a good agreement between experimental observations and simulation results has been achieved.

1216 Nano-Scale Strength Analysis by EBSD and AFM Hybrid Method in Ultrafine-Grained Copper Processed by ECAP

Microscopic Analysis by EBSD Method on Fatigue Crack Propagation Behaviour in Ultrafine-Grained Copper

Advanced Numerical Characterization of Mono-Crystalline Copper with Defects

Atomistic Exploration of Deformation Properties of Copper Nanowires with Pre-Existing Defects

Simulating Size and Volume Fraction-Dependent Strength and Ductility of Nanotwinned Composite Copper

Numerical investigation of fracture behavior of nanostructured Cu with bimodal grain size distribution

Investigation of fatigue mechanical properties of apolycrystalline solid at mesoscopic scale using depth-sensing indentation (DSI) technique

Effect of grain refinement on mechanical and electrochemical properties of severely deformed pure copper through equal channel angular pressing

Strain localization and ductile fracture mechanism of micro/mesoscale deformation in ultrafine-grained pure copper

In-situ SEM-EBSD investigation of the low-cycle fatigue deformation behavior of Inconel 718 at grain-scale

Effect of Electropulsing Treatment on the Fatigue Crack Growth Behavior of Copper

Deformation and Fracture Behavior of Electrocodeposited Alumina Nanoparticle/Copper Composite Films

An investigation of the combined size and rate effects on the mechanical responses of FCC metals

Experimental and Numerical Investigation of the ECAP Processed Copper: Microstructural Evolution, Crystallographic Texture and Hardness Homogeneity

Micro/nanostructure high strength and high conductivity CuCrZr alloy prepared through equal channel angular pressing and aging treatment

An investigation of slip transmission during uniaxial tensile deformation of a coarse-grained copper via EBSD characterization and crystal plasticity modelling

EBSD Analysis of Deformed and Partially Recrystallized Microstructures in ECAE-Processed Copper

Low cycle fatigue behavior of precipitation-strengthened Cu-Cr-Zr contact wires

Enhancement of fatigue resistance by recrystallization and grain growth to eliminate bonding interfaces in Cu–Cu joints

In situ high-cycle fatigue reveals the importance of grain boundary structure in nanocrystalline Cu-Zr

Characterization of microstructural evolution and mechanical properties of Cu-Ni-Cr alloys deformed by ECAP