Abstract:Thin-film polycrystalline silicon (pc-Si) on foreign (non-silicon) substrates has been researched by various research groups for the production of photovoltaic cells. High quality pc-Si deposition on foreign substrates with superior optical properties is considered to be the main hurdle in cell fabrication. Metal induced crystallization (MIC) is one of the renowned techniques used to produce this quality of material. In the current study, an aluminum induced crystallization (AIC) method was adopted to produce pc-Si thin-film on aluminum nitride (AlN) substrate by a seed layer approach. Aluminum and a-Si layer were deposited using an e-beam evaporator. Various annealing conditions were used in order to investigate the AIC grown pc-Si seed layers for process optimization. The effect of thermal annealing on grain size, defects preferentially crystallographic orientation of the grains were analyzed. Surface morphology was studied using an optical microscope. Poly-silicon film with a crystallinity fraction between 95-100% and an FWHM between 5-6 cm−1 is achievable at low temperatures and for short time intervals. A grain size of about 10 micron can be obtained at a low deposition rate on an AIN substrate. Similarly, Focused ion beam (FIB) also showed that at 425 °C sample B and at 400 °C sample A were fully crystallized. The crystalline quality of pc-Si was evaluated using μ-Raman spectroscopy as a function of annealed conditions and Grazing incidence X-ray diffraction (GIXRD) was used to determine the phase direction of the pc-Si layer. The current study implicates that a poly-silicon layer with good crystallographic orientation and crystallinity fraction is achievable on AIN substrate at low temperatures and short time frames.

Multicrystalline Silicon Assisted by Polycrystalline Silicon Slabs As Seeds

Multicrystalline Silicon Crystal Assisted by Silicon Flakes As Seeds

Preparation of High-performance Multicrystalline Silicon Ingot Based on Innovative Seeding Strategy for Recycled Seeds

Collaborative R&D Between Multicrystalline Silicon Ingots and Battery Efficiency Improvement—effect of Shadow Area in Multicrystalline Silicon Ingots on Cell Efficiency

Evaluation of Large-Scale Recycled Seed for Cast Monocrystalline Silicon: Defect Multiplication Mechanisms and Feasibility

Silicon Rich Carbide As A Conductive Substrate For Si Qd Solar Cells

(Invited) Defects in Cast-Mono Crystalline Silicon

Growth of low-cost and high-quality monocrystalline silicon ingots by using split recycled seeds

Seed-assisted Cast Quasi-Single Crystalline Silicon for Photovoltaic Application: Towards High Efficiency and Low Cost Silicon Solar Cells

The dislocation distribution characteristics of a multi-crystalline silicon ingot and its impact on the cell efficiency

Higher quality composite silicon ingot with monocrystalline and multicrystalline bricks

Seed-Assisted Growth of Cast-Mono Silicon for Photovoltaic Application: Challenges and Strategies

Higher Quality Mono-Like Cast Silicon with Induced Grain Boundaries

Improving quality of cast monocrystalline Si ingot with seed crystal strips and graphite soft felt

The characterization of high quality multicrystalline silicon by the electron beam induced current method

Controlling Dislocation Gliding and Propagation in Quasi-Single Crystalline Silicon by Using <110>-Oriented Seeds

SiC Contaminations in Polycrystalline-Silicon Wafer Directly Grown from Si Melt for Photovoltaic Applications

Designing Functional Σ13 Grain Boundaries at Seed Junctions for High-Quality Cast Quasi-Single Crystalline Silicon

Poly-crystalline thin-film by aluminum induced crystallization on aluminum nitride substrate

High-efficiency electroluminescence devices containing Si nanocrystals/SiC multilayers via improved carrier injection and recombination process

Effects of impurity barrier layer on the red zone at the bottom of cast monocrystalline Si ingot for solar cells