Abstract:Solid oxide fuel cells (SOFCs) can directly convert the chemical energy in fuels and oxidants into electrical energy because of their high operating temperatures, making them efficient and environmentally friendly. The high-temperature operating characteristic gives SOFCs numerous advantages, including flexible fuel capability and high efficiency. However, it leads to a non-uniform temperature distribution that results in the performance degradation of SOFCs or even system failure. Owing to the high-temperature and gas-sealed operating environment, measuring the temperature distribution in SOFC stacks using experimental methods is extremely difficult. In this study, an SOFC internal temperature measurement device is developed and constructed to investigate the impacts of various factors, including the operating current density and gas flow rate, on the electrical output performance and temperature distribution within an SOFC stack. The experimental results indicate that the SOFC temperature gradually increases with increasing current density. Furthermore, the temperature difference between the spatial locations increases, and the inhomogeneity of the temperature distribution becomes more significant. During the growth of the current density i from 0.1 A/cm 2 to 0.5 A/cm 2 , the maximum temperature gradient on the SOFC electrodes reaches the lowest level at i = 0.3 A/cm 2 . The maximum current density and power density increase as the gas flow rate increases. However, the electrical efficiency and fuel utilization ratio gradually decrease, and the uniformity of the temperature distribution deteriorates. Air flux is the main factor that dominates the temperature distribution in SOFCs. The temperature on the cathode side is higher than that on the anode side. These results contribute to understanding the temperature distribution patterns in SOFCs and provide some guiding significance for SOFC design and operation optimization.

Highly Thermal-integrated Flame Fuel Cell Module with High Temperature Heatpipe

A high performance intermediate temperature fuel cell based on a thick oxide–carbonate electrolyte

Highly Thermal Integrated Heat Pipe-Solid Oxide Fuel Cell

Biogas-Fueled Flame Fuel Cell for Micro-Combined Heat and Power System

Numerical Simulation and Optimization of Operating and Structural Parameters for Solid Oxide Fuel Cell

Experimental Study on High-Efficiency Microtubular Solid Oxide Fuel Cell Stacks Using Various Fuels

Integration of Solid Oxide Fuel Cells with Multi-Element Diffusion Flame Burners

Flat-chip Flame Fuel Cell Operated on a Catalytically Enhanced Porous Media Combustor

Start-Up and Operation Characteristics of A Flame Fuel Cell Unit

A Direct Flame Solid Oxide Fuel Cell for Potential Combined Heat and Power Generation

Micro-tubular Solid Oxide Fuel Cell Stack Operated with Catalytically Enhanced Porous Media Fuel-Rich Combustor

A novel silicon carbide plate-fin heat exchanger and its thermal and hydraulic performance for SOFC cathode air preheater application

Direct Flame Fuel Cell Performance Using A Multi-Element Diffusion Flame Burner

Power and Heat Co-Generation by Micro-Tubular Flame Fuel Cell on a Porous Media Burner

A Robust Flat-Chip Solid Oxide Fuel Cell Coupled with Catalytic Partial Oxidation of Methane

Thermal Shock Resistance and Failure Probability Analysis on Solid Oxide Electrolyte Direct Flame Fuel Cells

A novel flow field design with flow re-distribution for advanced thermal management in Solid oxide fuel cell

A High-Energy Module Containing a Micro-Tubular Solid Oxide Fuel Cell Coupled with Catalytic Partial Oxidation of N-Butane

Experimental Characterization of a Direct Methane Flame Solid Oxide Fuel Cell Power Generation Unit

Electrochemical characterization and degradation analysis of a flat-chip solid oxide fuel cell fed by ambient temperature inlet gas

Experimental investigation of temperature distribution in solid oxide fuel cells