Abstract:Solid oxide fuel cells (SOFCs) can directly convert the chemical energy in fuels and oxidants into electrical energy because of their high operating temperatures, making them efficient and environmentally friendly. The high-temperature operating characteristic gives SOFCs numerous advantages, including flexible fuel capability and high efficiency. However, it leads to a non-uniform temperature distribution that results in the performance degradation of SOFCs or even system failure. Owing to the high-temperature and gas-sealed operating environment, measuring the temperature distribution in SOFC stacks using experimental methods is extremely difficult. In this study, an SOFC internal temperature measurement device is developed and constructed to investigate the impacts of various factors, including the operating current density and gas flow rate, on the electrical output performance and temperature distribution within an SOFC stack. The experimental results indicate that the SOFC temperature gradually increases with increasing current density. Furthermore, the temperature difference between the spatial locations increases, and the inhomogeneity of the temperature distribution becomes more significant. During the growth of the current density i from 0.1 A/cm 2 to 0.5 A/cm 2 , the maximum temperature gradient on the SOFC electrodes reaches the lowest level at i = 0.3 A/cm 2 . The maximum current density and power density increase as the gas flow rate increases. However, the electrical efficiency and fuel utilization ratio gradually decrease, and the uniformity of the temperature distribution deteriorates. Air flux is the main factor that dominates the temperature distribution in SOFCs. The temperature on the cathode side is higher than that on the anode side. These results contribute to understanding the temperature distribution patterns in SOFCs and provide some guiding significance for SOFC design and operation optimization.

A novel flow field design with flow re-distribution for advanced thermal management in Solid oxide fuel cell

Numerical Simulation and Optimization of Operating and Structural Parameters for Solid Oxide Fuel Cell

Design of novel flow channels of tubular biomass-syngas fueled SOFC towards uniform temperature distribution

Towards Feasible Temperature Management and Thermo-Mechanical Stability of Carbon-Assisted Solid Oxide Electrolysis Cell

Experimental investigation of temperature distribution in solid oxide fuel cells

Local heat transfer enhancement by recirculation flows for temperature gradient reduction in a tubular SOFC

Numerical Investigation of Heat/Flow Transfer and Thermal Stress in an Anode-Supported Planar SOFC

Flow uniformity analysis and optimization of a 60-cell external manifold solid oxide cell stack with bottom-accesses

Three-dimensional numerical investigation on the effect of interconnect design on the performance of internal reforming planar solid oxide fuel cell

Comparison and optimization of electrochemical and thermal performances of SOFC with different configurations of a metal foam flow field

Analysis on temperature uniformity in methane-rich internal reforming solid oxide fuel cells (SOFCs)

Artificial Intelligence Based Structural Optimization of Solid Oxide Fuel Cell with Three-Dimensional Reticulated Trapezoidal Flow Field

A Reduced-Order Electrochemical Model for Analyzing Temperature Distributions in a Tubular Solid Oxide Fuel Cell Stack

A numerical study of the performance of solid oxide fuel cell with bi-layer interconnector

Numerical Analysis of Thermal Stress for a Stack of Planar Solid Oxide Fuel Cells

Structure optimization and thermal field analysis of biogas derived methane fueled Solid Oxide Fuel Cell

Effect of Radial Flows in Fuel Channels on Thermal Performance of Counterflow Tubular Solid Oxide Fuel Cells

A Review Of Heat Transfer And Thermal Management Methods For Temperature Gradient Reduction In Solid Oxide Fuel Cell (Sofc) Stacks

Numerical analysis of afterburner chamber design for solid oxide fuel cell system

Estimation of Spatial Temperature Distribution in Co-Flow Planar Solid Oxide Fuel Cells

A novel design of inlet/outlet header structure for improving flow uniformity and performance in planar solid oxide fuel cell