Abstract:Solid oxide fuel cells (SOFCs) can directly convert the chemical energy in fuels and oxidants into electrical energy because of their high operating temperatures, making them efficient and environmentally friendly. The high-temperature operating characteristic gives SOFCs numerous advantages, including flexible fuel capability and high efficiency. However, it leads to a non-uniform temperature distribution that results in the performance degradation of SOFCs or even system failure. Owing to the high-temperature and gas-sealed operating environment, measuring the temperature distribution in SOFC stacks using experimental methods is extremely difficult. In this study, an SOFC internal temperature measurement device is developed and constructed to investigate the impacts of various factors, including the operating current density and gas flow rate, on the electrical output performance and temperature distribution within an SOFC stack. The experimental results indicate that the SOFC temperature gradually increases with increasing current density. Furthermore, the temperature difference between the spatial locations increases, and the inhomogeneity of the temperature distribution becomes more significant. During the growth of the current density i from 0.1 A/cm 2 to 0.5 A/cm 2 , the maximum temperature gradient on the SOFC electrodes reaches the lowest level at i = 0.3 A/cm 2 . The maximum current density and power density increase as the gas flow rate increases. However, the electrical efficiency and fuel utilization ratio gradually decrease, and the uniformity of the temperature distribution deteriorates. Air flux is the main factor that dominates the temperature distribution in SOFCs. The temperature on the cathode side is higher than that on the anode side. These results contribute to understanding the temperature distribution patterns in SOFCs and provide some guiding significance for SOFC design and operation optimization.

Design of novel flow channels of tubular biomass-syngas fueled SOFC towards uniform temperature distribution

A Novel Flow Channel Design to Achieve High Temperature Homogenization in Solid Oxide Fuel Cell

A novel flow field design with flow re-distribution for advanced thermal management in Solid oxide fuel cell

Local heat transfer enhancement by recirculation flows for temperature gradient reduction in a tubular SOFC

Numerical Study of Temperature Distribution in Tubular Segmented-in-series SOFC with Co-Flow and Counter-Flow Arrangements

Experimental investigation of temperature distribution in solid oxide fuel cells

Effect of Radial Flows in Fuel Channels on Thermal Performance of Counterflow Tubular Solid Oxide Fuel Cells

Comparison and optimization of electrochemical and thermal performances of SOFC with different configurations of a metal foam flow field

Analysis of Mass Transfer Characteristics in a Planar Solid Oxide Fuel Cell with a Chaotic Flow Channel

Analysis on temperature uniformity in methane-rich internal reforming solid oxide fuel cells (SOFCs)

A Reduced-Order Electrochemical Model for Analyzing Temperature Distributions in a Tubular Solid Oxide Fuel Cell Stack

Three-dimensional numerical investigation on the effect of interconnect design on the performance of internal reforming planar solid oxide fuel cell

A Novel Control Scheme to Mitigate Temperature Profile Variation in a SOFC System

A numerical study of the performance of solid oxide fuel cell with bi-layer interconnector

Effects of Radial and Circumferential Flows on Power Density Improvements of Tubular Solid Oxide Fuel Cells

Parametric Study for Electrode Microstructure Influence on SOFC Performance

Optimization of interconnect flow channels width in a planar solid oxide fuel cell

Structure optimization and thermal field analysis of biogas derived methane fueled Solid Oxide Fuel Cell

Three‐dimensional Nonisothermal Modeling of Solid Oxide Fuel Cell Coupling Electrochemical Kinetics and Species Transport

Numerical Investigation of Heat/Flow Transfer and Thermal Stress in an Anode-Supported Planar SOFC

Numerical Study of a 20-Cell Tubular Segmented-in-series Solid Oxide Fuel Cell