Abstract:Solid oxide fuel cells (SOFCs) can directly convert the chemical energy in fuels and oxidants into electrical energy because of their high operating temperatures, making them efficient and environmentally friendly. The high-temperature operating characteristic gives SOFCs numerous advantages, including flexible fuel capability and high efficiency. However, it leads to a non-uniform temperature distribution that results in the performance degradation of SOFCs or even system failure. Owing to the high-temperature and gas-sealed operating environment, measuring the temperature distribution in SOFC stacks using experimental methods is extremely difficult. In this study, an SOFC internal temperature measurement device is developed and constructed to investigate the impacts of various factors, including the operating current density and gas flow rate, on the electrical output performance and temperature distribution within an SOFC stack. The experimental results indicate that the SOFC temperature gradually increases with increasing current density. Furthermore, the temperature difference between the spatial locations increases, and the inhomogeneity of the temperature distribution becomes more significant. During the growth of the current density i from 0.1 A/cm 2 to 0.5 A/cm 2 , the maximum temperature gradient on the SOFC electrodes reaches the lowest level at i = 0.3 A/cm 2 . The maximum current density and power density increase as the gas flow rate increases. However, the electrical efficiency and fuel utilization ratio gradually decrease, and the uniformity of the temperature distribution deteriorates. Air flux is the main factor that dominates the temperature distribution in SOFCs. The temperature on the cathode side is higher than that on the anode side. These results contribute to understanding the temperature distribution patterns in SOFCs and provide some guiding significance for SOFC design and operation optimization.

Three-dimensional numerical investigation on the effect of interconnect design on the performance of internal reforming planar solid oxide fuel cell

Performance Analysis of Flat-chip Solid Oxide Fuel Cells with Discrete Interconnector Designs

Numerical Simulation and Optimization of Operating and Structural Parameters for Solid Oxide Fuel Cell

Numerical Modeling and Current Collection Designs for Flat-Chip Solid Oxide Fuel Cell

Optimization of interconnect flow channels width in a planar solid oxide fuel cell

Numerical Investigation of Heat/Flow Transfer and Thermal Stress in an Anode-Supported Planar SOFC

A numerical study of the performance of solid oxide fuel cell with bi-layer interconnector

Discrete triangular interconnector design for performance enhancement of planar solid oxide fuel cells

Effect of the Reactant Transportation on Performance of a Planar Solid Oxide Fuel Cell

Simulation and Analysis of Thermal Stress and Sintering Warpage of Planar Solid Oxide Fuel Cells

Numerical simulation and thermal stress analysis of direct internal reforming SOFCs

Numerical Analysis of Thermal Stress for a Stack of Planar Solid Oxide Fuel Cells

Effect of Interconnector Rib on Optimization of SOFC Structural Parameters

A novel flow field design with flow re-distribution for advanced thermal management in Solid oxide fuel cell

Numerical Analysis of the Internal Fuel Processing in Solid Oxide Fuel Cells

Influence of Interface Morphology on the Thermal Stress Distribution of SOFC under Inhomogeneous Temperature Field

Numerical Investigation on Impacts on Fuel Velocity Distribution Nonuniformity among Solid Oxide Fuel Cell Unit Channels

Numerical Study on Effects of Flow Channel Length on Solid Oxide Fuel Cell-Integrated System Performances

Optimized design of planar solid oxide fuel cell interconnectors

Effect of Radial Flows in Fuel Channels on Thermal Performance of Counterflow Tubular Solid Oxide Fuel Cells

Experimental investigation of temperature distribution in solid oxide fuel cells